1) serial interface (COM)
串行接口(COM)
2) serial interface
串行接口
1.
Study on the communication scheme of signal modulation and demodulation based on serial interface;
基于串行接口信号调制/解调的通信方案研究
2.
PCB of micro controller serial interface for experiment;
单片机串行接口实验电路板的设计
3) serial port
串行接口
1.
RS—485 Serial Port and Industrial Control Local Area Network;
RS—485串行接口及其构成的工业测控网络
2.
Using a low-power CMOS 8-bit microcontroller ATmega8,ten-bit digital signals realizes analog-to digital conversion,and the converted signals are transmitted into the PC by RS232 serial port.
介绍了网上心电实时监护系统,应用ATmega8型8位微处理器芯片实现了10位精度的心电AD转换,通过RS232串行接口向PC机传送数据,并介绍这2部分的软、硬件设计思想。
3.
This paper introduces a design scheme of a serial port communication technology based on embedded gateway.
介绍了一种基于嵌入式网关的串行接口通讯的设计方案。
4) series interface
串行接口
1.
Integrated TTS processor SD178A and its series interface;
SD178A型集成式TTS处理器及其串行接口
2.
The characteristics of thesystem ,the series interface circuits and the useful anti-interference methods used in thesystem have been analysed.
本文介绍一种网络结构的微机实时监测系统,分析了系统的特点、串行接口电路和有效抗干扰措施。
3.
This paper designs a series interface between ARPA (JAS-800 for example) and speech output system.
本文以JAS-800为例设计出语音输出系统与ARPA间的串行接口,使之从ARPA中的引出线减少到10根。
5) COM interface
COM接口
1.
This paper presents the basic principle of IE binary behaviors,and redefines the COM interfaces according to their primary semantics and the feature of(.
概述了IE二进制行为组件的工作原理,根据其COM接口原始语义,针对。
2.
This paper simply introduces the COM interface and its deve loping method, and by examples explains how to use Visual C++to make the secon dary development of SolidWorks.
介绍了SolidWorks的COM接口及其开发方法,并通过实例说明如何利用开发工具VC对SolidWorks进行二次开发。
6) SPI serial interface
SPI串行接口
1.
Using the SPI serial interface and the MC14489 management chip constitute the intellectualized instrument measuring appliance,the demonstration actuation electric circuit to be possible to cause the systems performance price compared to obtain the large scale enhancement.
采用SPI串行接口和MC14489管理芯片来构成智能化仪器仪表的显示驱动电路可使系统的性能价格比获得大幅度的提高。
补充资料:串行计算机
分子式:
CAS号:
性质:(一)只有一个逻辑与算术单元的计算机。(二)具有串行工作特点的计算机,即采用串行传送方式和串行操作方式的计算机
CAS号:
性质:(一)只有一个逻辑与算术单元的计算机。(二)具有串行工作特点的计算机,即采用串行传送方式和串行操作方式的计算机
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条