说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 960MHz介质滤波器
1)  960 MHz dielectric filter
960MHz介质滤波器
2)  dielectric filter
介质滤波器
1.
Simulation of 900 MHz single-block coaxial microwave dielectric filter;
900MHz独块同轴微波介质滤波器的仿真
2.
A new HTS(High Temperature Superconductor) dielectric filter design method is introduced,in which cylinder dielectric resonators are aligned in a single copper shield cavity with two HTS thin films placed on both ends of the resonators.
本文提出了采用单个屏蔽腔设计超导介质滤波器的方法,在腔内并列摆放多个圆柱形介质谐振器,在谐振器上下两个端面均采用一片超导薄膜作为短路面,滤波器结构紧凑,制备工艺简单。
3.
This paper introduces the design principle and calculating method of a 1800MHz microwave dielectric filter consisting of coaxial resonator, and uses High Frequency Structure Simulation (HFSS) software to simulate the design.
研究18 0 0MHz的微波介质滤波器的设计原理和计算方法,同时使用高频结构仿真软件对所设计的滤波器进行了仿真分析。
3)  dielectric filters
介质滤波器
1.
This kind of material is used to make dielectric filters and miniature,light and chip coponents for communication equipments in decimeter-wave region.
利用该种材料制成了介质滤波器及分米波通信设备用的小型、轻量的片式元器件。
2.
A kind of coaxial dielectric filters with capacitor-loaded structure was designed and studied.
设计并研究了一种电容负载型的同轴介质滤波器,它采用新颖的耦合结构,以及高介电常数低损耗的微波陶瓷材料,大大减小了同轴介质滤波器的体积。
4)  microwave dielectric filter
微波介质滤波器
1.
This paper described a designing method of a new structure microwave dielectric filter.
详细论述了一种新型结构微波介质滤波器的设计方法,分析了滤波器结构中耦合结构与谐振结构的相互影响关系,根据微波网络理论计算出的微波介质滤波器结构参数值,并采用高频结构模拟软件(HFSS)对滤波器结构进行仿真优化,得到了性能满足要求的仿真结果,根据仿真优化的结果制备出的微波介质滤波器其性能与设计要求相吻合。
5)  MHz dielectric filter
980MHz介质滤波器
6)  dielectric dual-mode filter
双模介质滤波器
1.
Structure design and analysis of a 4th-degree dielectric dual-mode filter
四阶双模介质滤波器的设计和分析
2.
This paper introduces the design principle and calculating method of a 2 140 MHz microwave dielectric dual-mode filter,and uses High Frequency Structure Simulation software to simulate the design.
研究对于CDMA频段2140MHz的微波双模介质滤波器的设计原理和计算方法,同时使用高频结构仿真软件对所设计的滤波器进行了仿真分析。
补充资料:波数字滤波器
      由两端终接电阻负载的无源LC梯形滤波器导出的一种数字滤波器结构。应用双线性变换S=k(1-Z-1)/(1+Z-1)可将用波参数描述的无源元件,实现为数字元件。表1列出了无源元件R、C、L及其对应的由延时单元、乘法器和加法器构成的数字元件。
  
  
  通常高阶递归型数字滤波器的级联型或并联型有产生极限环振荡的危险。此外,在输入信号非常小时,由于舍入误差的高度相关,也可能导致数字滤波器的不稳定而产生固定振荡。1971年,提出波数字滤波器的伪无源性概念,并论证了这种数字滤波器的低灵敏度特性。波数字滤波器具有良好的稳定性,可以用较短的系数字长实现,有良好的动态范围,不会出现极限环振荡(即在环路情况下应用也不会出现任何杂散振荡)。这种数字滤波器特别适用于通信系统。
  
  在波数字滤波器结构中,用波参数描述的元件,在联接时必须遵从端口间阻抗匹配的原则。相应地,数字元件之间的联接按其为串联或并联分别采用由乘法器和加法器构成的串联适配器或并联适配器匹配联接。适配器符号及其对应的联接关系见表2。图为三阶椭圆型低通LC 梯形滤波器及其等效的波数字滤波器。  波数字滤波器的另一种结构称为波格型数字滤波器,是由对称型或格型无源LC 滤波器导出的。
  
  

参考书目
   A. Antonious, Digital Filter : Analysis and Design,McGraw-Hill Co.,New York,1979.
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条