说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 最优测试集
1)  optimal test set
最优测试集
1.
The design of generating circuit optimal test set based on BP neural network
基于BP神经网络的电路最优测试集的生成设计
2.
In this paper,the design of optimal test set based on evolutionary programming algorithm is applied on the actual circuit board hardware.
应用进化规划算法对实际电路板硬件进行最优测试集的生成设计。
2)  optimum test set
最优化测试集合
3)  optimal observation set
最优观测集
1.
This paper improves the methods of observation reduction in non-deterministic planning(NDP) in three aspects:in finding MOS(minimal observation set);in finding out the optimal observation set(OOS) when observations have different costs;and in finding fault-tolerant OOS.
从3个方面改进了不确定规划(non-deterministic planning,简称NDP)中的观测约简:一是如何找最小观测集合(minimal observation set,简称MOS),二是如何在观测代价不均等时找最优观测集合(optimal observation set,简称OOS),三是如何找到容错的OOS。
4)  optimal test tree
最优测试树
1.
The problem of constructing optimal test tree is a NP complete problem.
测试树问题属一类应用十分广泛的二元识别问题范畴,求解最优测试树是一个NP完全问题,本文提出了基于遗传算法构造最优测试树的方法,并通过实例研究了算法的有效性。
5)  Test set optimization
测试集优化
1.
According to the actual characteristics of fault test set optimization,the particle expression and coding rule are constructed,and the speed-position model of PSO is established for fault test set optimization of digital integrated circuits.
文中利用粒子群优化算法生成最小完备测试集,根据故障测试集优化问题的具体特点,构造粒子的表达方式和编码规则,建立粒子群的速度—位置模型;同时为提高优化效率,引入混沌优化算法来初始化粒子群。
2.
In this paper,a test set optimization method based on the genetic reordering is presented,which optimizes the row vectors order of the test set s vector-fault matrix by genetic algorithm and adopts the row-column elimination as the evaluation method in the genetic process.
测试集优化是数字电路测试的一个基本问题。
6)  minimum test set
最小测试集
补充资料:测试结果可接受性的检查和最终测试结果的确定


测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result

  C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条