1) high-water-head tunnel
高水头隧洞
1.
lt′s an expensive waste of funds for adopting the heavy lining with steel and rein-forced concrete in the construction of high-water-head tunnel,and would saving by halfin funds when adopting the newly developed shotcrete and bolt supporting.
本文指出目前我国在建设高水头隧洞时采用钢管和钢筋混凝土衬砌是资金上的巨大浪费，而新型的锚喷支护则可减半地节约。
2) Leading face of the diversion tunnel
独头引水隧洞
3) high pressure conveying water tunnel
高压输水隧洞
1.
But according to the results of hydraulic fracturing test and the minimum principal stress criterion,the steel liners of the high pressure conveying water tunnel and even at the branch section are all cancelled,and just supported by reinforced concrete liner with thickness of 60 cm.
在高压输水隧洞及地下厂房围岩中,遇水膨胀的蚀变岩带十分发育。
4) high pressure water carriage tunnel
高压引水隧洞
1.
On the basis of concrete lining deformation character with crack emerged, a design method of high pressure water carriage tunnel lining is put up.
在借助渗流体积力考虑渗流场的力学效应，并由室内试验获得渗透系数随应力水平而变化的关系式的基础上，建立了裂缝混凝土衬砌和渗水围岩地层中渗流场与应力场的耦合计算模型，然后根据衬砌混凝土裂缝出现和开展后的受力变形的特征，提出了一种可供高压引水隧洞衬砌配筋采用的计算方法，并将其应用于广蓄电站二期工程高压引水隧洞衬砌的设计研究。
5) high pressure tunnel
水工高压隧洞
6) tunnel plug
隧洞堵头
1.
Temperature control calculation and analysis for diversion tunnel plug of Baise Multipurpose Dam Project;
百色水利枢纽导流隧洞堵头温控计算分析
补充资料：梳水头
见假发。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条