说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 点验证
1)  point verification
点验证
1.
The processor uses either a cooperating mode or a separate mode to support not only several elliptic curve digital signature algorithms,but also scalar multiplication,point addition and point verification.
它不但可以两个核单独或者协同完成多种椭圆曲线数字签名算法,同时还支持多倍点、点加以及点验证运算。
2)  validation node
验证点
1.
Secure localization protocol based on validation node in wireless sensor network;
无线传感器网络中基于验证点的安全定位协议
3)  verification,nodal
节点验证
4)  Minutiae verification
细节点验证
1.
To improve the performance of automatic fingerprint recognition and promoting its application, the dissertation discusses the problems of fingerprint minutiae extraction, fingerprint minutiae verification and fingerprint minutiae matching, using the knowledge of digital image processing, pattern recognition and computational i.
(2)提出了基于模糊几何特征和纹理特征的细节点验证方法。
5)  Experimental Certification
验证验证
6)  validation [英][,væli'deiʃən]  [美][,vælə'deʃən]
验证
1.
Validation of Analytical Procedures in European and American Drug Registration Files;
欧美原料药进口注册文件中的分析方法验证
2.
Something Need to be Considered in Validation of Autoclaves;
高压蒸汽灭菌柜验证中需注意的几个问题
3.
Validation the GMP of Hospital Medicinal Drugs Preparation;
医院制剂产品GMP验证初探
补充资料:闭式单点、双点压力机
代码:00413
设备名称:闭式单点、双点压力机
型号规格:公称力≥800kN
计量单位:台
主要参数内容
国际先进国内先进国内一般国内落后评定方法及说明
(一)加工精度
    参照GB10924-89、GB10933-89、JB5200-91
1、滑块下平面对工作台上平面的平行度(mm)
30%精度储备20%精度储备达到规定值大于规定值 
0.02+0.10/100×滑块下平面的被测长度
     
2、滑块行程对工作台上平面的垂直度
30%精度储备20%精度储备达到规定值大于规定值 
0.05+0.02/100×滑块行程长度
     
(二)结构性能
     
1、离合器、制动器接通率,当滑块行程次数≤16次/分时为70%,≤25次/分时为60%,≤45次/分时为50%
大于规定值10%大于规定值达到规定值达不到规定值 
2、液压超负荷保险装置、微调装置、吨位指示器
全部具有全部具有部分具有没有 
(三)噪声dB(A)
     
1、公称力≤400kN
≤85≤87≤88>88 
2、公称力>400kN
≤87≤88≤90>90 
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条