1) micro algorithm
显微算法
1.
This paper is concerned with putting forward a micro algorithm used to research the fine construction of Mandelbrot set under a general complex, and using it to analyze and study the feature of the fractal figure of Mandelbrot set.
提出用于研究一般复映射的Mandelbrot集精细结构的显微算法 ,并利用此算法分析研究Mandelbrot分形图的特
2) ultramicroscopic method
超显微法
1.
Light scatter was detected with an ultramicroscopic method.
选用硫酸钾、硝酸钾和氯化钾作为掺杂剂,采用传统降温法和“点籽晶”快速法生长了磷酸二氢钾(KDP)晶体,利用超显微法对KDP晶体中的散射颗粒进行了观察,研究了SO42-、NO3-和Cl-三种阴离子掺杂对晶体中光散射的影响。
3) microscope testing
显微镜法
1.
The different defat and staining was compacted the raw milk,then compared the count of the somatic cell count by the microscope testing,and copared with the result of DHI.
对生鲜奶样进行不同的脱脂和染色处理,然后用显微镜法计数,并与DHI法检测结果进行比较,从而确定可行的脱脂和染色方法,为生产实践提供借鉴。
4) micrometer measurement method
显微测微法
1.
Changes of pericarp thickmess of seven elite inbred tines of three different genotypes and their four F1 combination of maize were studied by the micrometer measurement method.
采用显微测微法对3种不同基因型的7个玉米骨干系及由它们配制的4个杂交组合F1的果皮厚度变化规律进行了研究。
5) explicit algorithm
显式算法
1.
Based on the actual structure and specific working character of disk spring,experimentation was done on combination disk spring and the process of continuous load as well as load—unload of congruent disk spring was imitated with nonlinear explicit algorithm of the finite element software ANSYS/LS—DYNA.
从碟簧的实际结构特征和具体工作特点出发,对组合碟簧进行静刚度试验测试,并利用有限元软件ANSYS/LS—DYNA的非线性显式算法进行计算,对叠合碟簧的连续加载以及加载—卸载过程进行数值模拟,得到碟簧的载荷位移关系曲线。
6) display algorithm
显示算法
1.
Its display algorithm is based on pixel-operation.
传统的LCD显示系统以点为单位,显示算法都围绕低效率的点操作进行。
2.
And the basic method to re-build the 3D object face with equivalenc e-area direct display algorithm is expounded.
介绍了一个能有效消除等值面显示中易出现的锯齿状走样现 象，可以生成非常细腻的三维物体表面图象的等值面高质量显示算法。
补充资料：高分辨电子显微镜(见高分辨电子显微术)
高分辨电子显微镜(见高分辨电子显微术)
high resolution electron microscope
高分辨电子显微镜high resolution eleetronmieroseope见高分辫电子显微术。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条