1)  oil emulsion
油乳
2)  emulsification
煤油乳化
1.
We discussed the factors that influenced emulsification systems formed by alkali and kerosene,these factors mainly included the category of alkali,the concentration of oleic acid and alkali,and the salinity of water phase and HPAM.
分析碱液的种类和质量分数、油酸的质量分数、矿化度,以及聚合物对碱水煤油乳化效果的影响,得出在45℃条件下,碱水煤油乳化的最佳条件为油酸在油相中的质量分数为4。
3)  crude oil emulsion
原油乳液
1.
The results showed that the stability of water in Shaqing crude oil emulsion is the lest stable when aq.
研究了水相pH值、非离子破乳剂和助剂对沙轻原油、阿曼原油、杰诺原油、胜利原油乳液稳定性的影响 ,考察了破乳剂与助剂的协同效应。
4)  diesel oil emulsion
柴油乳液
1.
In this paper, the diesel oil emulsion, which is made up of diesel oil (material) , water and non -ionic surfactants of OP - 15(primary emulsifying agent) , Span - 80(accessorial emulsifying agent) , has been researched with experiments.
以柴油为原料,采用非离子表面活性剂聚乙二醇辛基醚(OP-15)作为主乳化剂,以脂肪酸二乙醇酰胺和山梨糖醇酐单油酸脂(Span-80)为辅乳化剂,对掺水柴油乳状液的配制条件进行实验,确定了不同用量的乳化剂形成W/O型乳液时的最大掺水量,同时考察了不同的燃烧条件下掺水柴油乳液的燃烧性能。
5)  diesel oil emulsification
柴油乳化
1.
The working principle and hardware as well as software of diesel oil emulsification equipment based on single chip microcomputer to optimize the performance of diesel oil are rutroduced.
就提高柴油性能给出了一种基于单片机控制的全自动柴油乳化装置的工作原理及软硬件的实现方法。
6)  oil emulsion
油乳剂
1.
kinds of oil emulsion were adopted to determine such physical characters as surface tension,grain density, uniformity and stability.
制备 6种不同剂型的油乳剂,将油乳剂分别在常温(2 0 - 2 3℃)、冷藏(4℃)、冷冻( - 2 0℃)后融化处理,测定各油乳剂经不同处理后的表面张力、分散相粒度及均匀度和油乳剂的稳定性,分析测定结果。
参考词条
补充资料：成色剂油乳
分子式：
CAS号：

性质：油溶性成色剂用一定比例的高沸点溶剂(如磷酸三甲酚酯、苯二甲酸、二丁酯等)和低沸点溶剂(为乙酸乙酯、环己酮等)加热溶解成溶液后，借助分散手段(如高速搅拌、超声、胶体磨等)分散入明胶水溶液中，形成液-液胶态分散体系，称为成色剂油乳。油乳粒径一般控制在0.1～1μm间，粒径愈小，成色剂与显影剂氧化物偶合成染料的效率越高。油乳在5～10℃下贮藏备用。

说明：补充资料仅用于学习参考，请勿用于其它任何用途。