1) oil emulsion
油乳法
1.
Two kinds of titania-containing microspheres (pure titanium dioxide and titania-zirconia) were prepared by oil emulsion technology.
以四氯化钛（TiCl4）和氧氯化锆（ZrOCl2·8H2O）为原料,采用油乳法制备了氧化钛和钛锆氧化物复合色谱填料。
2) oil emulsion
油乳
3) emulsification
煤油乳化
1.
We discussed the factors that influenced emulsification systems formed by alkali and kerosene,these factors mainly included the category of alkali,the concentration of oleic acid and alkali,and the salinity of water phase and HPAM.
分析碱液的种类和质量分数、油酸的质量分数、矿化度,以及聚合物对碱水煤油乳化效果的影响,得出在45℃条件下,碱水煤油乳化的最佳条件为油酸在油相中的质量分数为4。
4) crude oil emulsion
原油乳液
1.
The results showed that the stability of water in Shaqing crude oil emulsion is the lest stable when aq.
研究了水相pH值、非离子破乳剂和助剂对沙轻原油、阿曼原油、杰诺原油、胜利原油乳液稳定性的影响 ,考察了破乳剂与助剂的协同效应。
5) diesel oil emulsion
柴油乳液
1.
In this paper, the diesel oil emulsion, which is made up of diesel oil (material) , water and non -ionic surfactants of OP - 15(primary emulsifying agent) , Span - 80(accessorial emulsifying agent) , has been researched with experiments.
以柴油为原料,采用非离子表面活性剂聚乙二醇辛基醚(OP-15)作为主乳化剂,以脂肪酸二乙醇酰胺和山梨糖醇酐单油酸脂(Span-80)为辅乳化剂,对掺水柴油乳状液的配制条件进行实验,确定了不同用量的乳化剂形成W/O型乳液时的最大掺水量,同时考察了不同的燃烧条件下掺水柴油乳液的燃烧性能。
6) diesel oil emulsification
柴油乳化
1.
The working principle and hardware as well as software of diesel oil emulsification equipment based on single chip microcomputer to optimize the performance of diesel oil are rutroduced.
就提高柴油性能给出了一种基于单片机控制的全自动柴油乳化装置的工作原理及软硬件的实现方法。
参考词条
补充资料：皂化溶解油、肥皂油和调水油
分子式：
CAS号：
性质：又称皂化溶解油、肥皂油和调水油。金属切削油的一类。一般是淡褐色至深褐以液体或半固体。由在矿物油中加入适量的皂类乳化剂（如钠皂、钾皂、松香钠皂、松香皂或环烷酸钠皂）和少量稳定剂（如乙醇或甲醇）而成。使用时与软水掺合成稳定的白色乳化液。作用以冷却为主，润滑为次。用于车制、锯断、钻孔、磨制等金属粗加工。
CAS号：
性质：又称皂化溶解油、肥皂油和调水油。金属切削油的一类。一般是淡褐色至深褐以液体或半固体。由在矿物油中加入适量的皂类乳化剂（如钠皂、钾皂、松香钠皂、松香皂或环烷酸钠皂）和少量稳定剂（如乙醇或甲醇）而成。使用时与软水掺合成稳定的白色乳化液。作用以冷却为主，润滑为次。用于车制、锯断、钻孔、磨制等金属粗加工。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。