1) output point
输出点
1.
This paper mainly set forth the ways to solve the problem of the insufficient input and output points of PLC by improving wiring and programming, and these also can decrease the cost of hardware in PLC control system.
主要阐述通过改进接线与编程相结合解决PLC输入 /输出点不足的几种方法 ,从而降低PLC控制系统硬件的费
2) input and output number
输入、输出点
3) dot matrix output
点阵输出
1.
In the light of varying feature of pull deformable parmeters ,“Bivariate interacting-control monitor step”is used to decide whether sampling will be abandoned or remained,which can make the moriter data|'s processing &pull curve's dot matrix output.
针对拉伸实验中拉力与变形参数变化特点，利用“双变量联控检测步长”方法来决定采样值的弃与留，使采样数值分布均匀， 弃舍合理，更便于检测数据 的处理和拉伸曲线的点阵输出。
4) output on single point
单点输出
1.
A multi-end-pumped two-mirrors nonplanar ring laser with output on single point was demonstrated.
提出并实现了多点抽运、单点输出的双镜非平面环行激光器。
5) output spots array
输出点阵
6) zero point output
零点输出
1.
Research of the zero point output of piezoresistive pressure sensor;
压阻式压力传感器零点输出研究
补充资料：黄金输出点
黄金输出点
【黄金输出点】参见“黄金点”。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条