1) model wave
模板波形
1.
We classity the abnormal ECG,store the model wave,and get statistical data of abnormal hap- penings.
用微型描绘打印机回放存贮的模板波形和统计表。
2) MRTW
修正接收模板波形
3) corrugated plates
波形板
1.
The mixture of air and atomized water was used in the experiment instead of steam-water,the separating efficiency of three kind of corrugated plates(without hook,with single hook,with double hook) were measured respectively under various inlet velocity,and the dimensionless formula for predicting the.
为了深入研究波形板内的液滴分离和二次携带现象的机理,优化波形板结构,针对波形板汽-水分离器展开了冷态实验分析。
2.
To optimize the design,the flow fields of different structures and spaces in the condition of cold and actual operation state of corrugated plates dryer are simulated by the fluent computation code.
采用FLUENT软件对波形板干燥器的5种波形板板型在3种不同板间距下的汽流场进行了模拟计算。
4) wave-shaped
波形梁板
1.
The configuration of punching equipment and its accessories for wave-shaped beam plate is introduced, the problems rose in application analyzed, and the methods to resolve them proposed.
介绍了波形梁板的冲孔设备及其工装的配置，分析了应用中遇到的问题，提出了解决办法。
5) contoured screen baskets
波形筛板
6) corrugated plate
波形板
1.
Analysis of the Influence of Turbulent Flow Effect on the Corrugated Plate Stream-Water Separators With Drain Hooks;
湍流效应对带钩波形板气水分离器的影响分析
2.
The behavior of droplet of steam-water separator with corrugated plate is simulated by founding a two-phase and three-flow-field numerical model consid- ering to the reentrainment.
本文对波形板汽水分离器进行了数值模拟和试验研究。
3.
Due to the complexity of two phase flow in corrugated plates, the research on steam separation system in steam generator is carried out mainly in the way of experiments.
由于波形板内的两相流动过程很复杂,目前国外对汽水分离器的研究仍以实验为主。
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条