1) joint influential matrix
结点影响矩阵
1.
After the concept of joint influential matrix is adopted in this paper, the forces and displacements of folding cantilever stairs in arbitary continuous span can be calculated by the method of transport matrix.
引入了结点影响矩阵的概念,应用传递矩阵法解决了任意连续多跨折线形悬挑楼梯的内力和位移计算。
2) influence matrix
影响矩阵
1.
The results obtained by the non-linear programming method are in agreement with those by the influence matrix method.
基于分段悬链线法,介绍自锚式悬索桥主缆线形计算原理和步骤,考虑弯矩对加劲梁轴向刚度的影响,在迭代计算过程中,提出采用非线性规划方法,并与传统的影响矩阵法进行对比,计算结果表明,两者结果吻合,从而使借助大型通用优化软件对自锚式悬索桥主缆线形进行精确求解成为可能。
2.
This paper gives the example using cable-stayed bend bridge with minimum radius in China,offsetting unclosed state by influence matrix and iterative method.
以国内弯道半径最小的斜拉桥为例,引入影响矩阵,通过迭代消除不闭合问题,从而可使施工索力得到优化,达到预先设定的成桥内力和线形。
3.
An efficient computational method of the influence matrix is proposed for cable force optimi-zation so as to calculate the cable force of cable-stayed bridges under dead loads easily.
文章提出了一种简便的计算影响矩阵的方法,可以方便地进行斜拉桥成桥恒载索力优化。
3) effect matrix
影响矩阵
1.
Application of BP neural network in the effect matrix of flatness control;
BP神经网络在板形控制影响矩阵中的应用
2.
By using the effect matrix,the nonlinear earthquake response of bridges under multi-support excitation is discussed in this paper.
通过影响矩阵讨论桥梁在多点激振下的非线性地震响应 ,并用算例比较一致输入和多点激振下的线性和非线性响应 ,讨论地震动输入方式和结构参数对地震响应的影响。
3.
In the nonlinear respondense analysis of bridges under multi support excitation,the effect matrix and Wilson θ method are used.
:用影响矩阵考虑了桥梁在多点激振下的非线性地震响应 ,并利用 Wilsom-θ法编制了相应的程序 。
4) effective matrix
影响矩阵
1.
A concept of system effective matrix is presented, and subsequently, a new method-effective matrix based diagnosis is given.
提出了系统影响矩阵的概念，在此基础上提出了故障诊断的一种新方法——基于影响矩阵的诊断方法。
5) influence matrix method
影响矩阵法
1.
After a careful review of existing methods of optimization of cable tensions for cable-stayed bridges, the authors think that influence matrix method is perfect theoretically.
对现有斜拉桥索力优化理论进行评述,认为索力优化的影响矩阵法在理论上最为完善。
6) influence coefficient matrix
影响系数矩阵
1.
The method of influence coefficient matrix which is successfully used in the Sino UK project of the Riv.
本文介绍的影响系数矩阵法可以方便快捷地完成上述各项工作。
补充资料：点接触结（pointcontactjunction）
点接触结（pointcontactjunction）
简便的方式是将超导体一削尖的端点（约0.1μm端径）施压在另一超导体小面上而接触成点接触结，它是一种弱连接。由于压力可调节，就可选择最好所需最适宜接触性能。点接触结可用于制作磁强计和微波接收与发射等装置。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条