1) broken-line fault
纵向故障
1.
This paper describes a mathematic mode of unbalanced three-phase power system,derives the formula for broken-line faults calculation and gives the program block diagram.
讨论了三相参数不对称电力系统纵向故障计算的数学模型，推导了有关计算公式，给出了计算框图。
2) fault direction
故障方向
1.
Based on the character that some bus nodes can judge the fault direction by current measurement in DG system, this paper presents an adaptive searching algorithm for dividing relevant fault area.
结合多DG接入下的配电网部分母线节点可以通过电流量来判断故障方向的特点,提出了一种具有较强自适应性的故障相关区域划分方法,而这种分布式的、缩小上传保护电流数据范围的算法减少了保护数据在信道上排队避让的时间,保护装置只需得到故障相关区域内的故障电流数据即可正确动作,实现了保护的选择性及速动性,降低了对通信系统的依赖性。
2.
Wide area relaying protection system collects fault direction information from protection intelligent electronic devices (IEDs) in specific protection zone, and estimates fault site based on protection Action Factor (AF) and Relationship Factor (RF) that are defined in this paper.
该算法通过广域继电保护系统收集特定保护范围内各智能电子设备(IED)的故障方向信息,结合文中定义的IED动作系数AF和关联系数RF进行简单运算,即可确定出故障的位置。
3.
When a fault occurs in power network,Primary Devices/Fault Direction associated matrices are formed based on the fault direction indicated by direction elements and Pri.
系统发生故障后,根据方向元件指示的故障方向信息和一次设备/方向元件关联矩阵形成一次设备/故障方向关联矩阵,并据此确定具体的故障元件。
3) reversal fault
换向故障
4) anti fault
反向故障
1.
On the basis of analyzing the error action of ground distance protection of LFP system in anti faults,it points out its fault in principle and puts forward a new solve method.
通过对LFP系列接地距离保护在反向故障时动作情况的分析 ,提出其原理上存在的缺陷 ,并给出了解决对
补充资料：L2工业纯铝360℃热轧板中心区域纵向组织
L2工业纯铝360℃热轧板中心区域纵向组织
L2工业纯铝560。0热轧板中心区域纵向组织
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条