1) extended dynamite tube
引伸药筒
2) drawing
[英]['drɔ:ɪŋ] [美]['drɔ·ɪŋ]
引伸
1.
Study on Spinning-drawing Equipment for Deep Tube;
深筒形件旋压引伸设备的研究
2.
The study on the drawing mould vibration and the numerical simulation of forming precision;
引伸模的振动分析及成形精度的数值模拟
3.
Study on the Rolling-Drawing Compound Forming Process;
辊压引伸复合成形工艺研究
3) ironing
[英]['aɪənɪŋ] [美]['aɪɚnɪŋ]
引伸
1.
But the strength of the cartridge case after ironing drawing cannot be accurately calculated by this formula,because the result of calculation is lower than that reached in practice.
用常规的幂强化公式计算药筒在引伸后的强度时，数值偏低较多，原因是该公式未考虑引伸凹模锥角对强化的影响。
4) cartridge
[英]['kɑ:trɪdʒ] [美]['kɑrtrɪdʒ]
药筒
1.
Failure analysis of small caliber ammunition cartridge cracking after shooting test was carried out by means of macro check,microanalysis of fracture,element analysis,metallographic constituent assessing,and magnetic particle test.
通过宏观观察、微观断口分析、成分分析、金相分析和磁粉探伤等方法对靶试后出现开裂的某小口径弹药药筒进行了失效分析。
2.
in this paper a sectional ring parametricelement model of barrel and cartridge is constructedin accordance with the characteristics of varyingclearance and taper between the cartridge and barrel of the automatic weapon, and an incrementalelasto-plastic finite element equation is established.
本文针对自动武器中药筒和身管变形的变间隙、变锥度的特点，构造了身管和药筒的截面环等参元分析模型，并据此建立了相应的增量形式的弹塑性有限元求解方程。
5) cartridge case
药筒
1.
The analysis for emission stresses of cartridge cases is a complicated nonlinear interaction between cartridge and tube.
药筒的发射强度问题是药筒与身管之间互相接触的复杂的非线性问题。
2.
In the paper the no linear FEA is used to calculate the stress of cartridge cases in emission and the forces for extraction.
应用非线性有限元方法计算药筒的发射应力和抽壳力。
3.
But the strength of the cartridge case after ironing drawing cannot be accurately calculated by this formula,because the result of calculation is lower than that reached in practice.
火炮药筒的强度是利用冲压加工时的应变强化达到的。
6) Cylinder Expansion-Extension
筒体展伸
补充资料：鹤引禽伸
1.指模仿鹤等鸟类屈伸肢体的动作。谓做气功之类。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条