1) edge seal
封油边
1.
In connection with the tapered flat thrust bearing with both edge seals which are set on the inner and outer rims of the pad respectively, this paper presents the calculation and analysis of the effect of the important parameter——film thickness ratio on the performance of bearings and gives out its optimum value.
针对瓦面上沿内、外径同时设置封油边的斜－平面扇形瓦块止推轴承，就基本参数——膜厚比对轴承性能的影响进行了计算和分析，并提出了这种轴承的最佳膜厚比值。
2) Seal lip type
唇边油封
3) edge_folding technology of oil_seal insert
油封嵌件折边
4) regular polygon holder sealed by thin oil
正多边形稀油密封
5) Sealing Edge
封边
1.
It is considered that the sealing edge of air bag should possess good properties, such as low permeability, good weavability and fracture resistance etc.
探讨了全成形气囊封边的组织设计时所需考虑的封边良好的阻气性能、可织造性能和抗破坏性能等因素。
6) oil seal
油封
1.
Framework-oil seal design and manufacture of oil die for car rear axle;
轿车后桥半轴骨架油封模具设计与制造
2.
Finite Element Analysis of Dynamic Sealing Performance of oil seal;
油封动态密封性能的分析
3.
ANSYS was utilized to establish the two-dimensional axisymmetric finite element model of oil seal.
利用ANSYS建立了橡胶油封的2维轴对称模型,分析了过盈量、唇口接触宽度R,弹簧劲度以及后唇角β与油封唇口压力大小及分布的关系。
补充资料：边封
1.犹边境。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条