1) optimum stiffness
最佳刚度
1.
A base isolated rigid body system is assumed to be subjected to steady harmonic excitation and the response is to be analyzed, The optimum stiffness of the isolated layer of the multistory masonry building with different damping ratios is suggested.
本文建立了具有复位能力的球支撑滚动隔震体系的计算模型和运动方程,对刚体隔震体系在简谐波激励下的反应进行了分析和研究,对一般剪切型结构,从理论上初步提出了隔震层的最佳刚度问题,给出了设置隔震层时单质点振子的反应谱曲线。
2.
By using sidesway calculation formula for frame-tube structures with top horizontal outriggers,the optimization stiffness of outriggers in the frame-tube structures with strengthened story are analyzed the method to determine the optimum stiffness of the horizontal outriggers magnitude and precise parameters base on reduced structure sidesway is presented.
利用带水平伸臂的框架—筒体结构侧移公式,对带加强层的框架—筒体结构水平伸臂的最佳刚度进行了分析,明确给出了根据需要减少的结构侧移量,确定水平伸臂最佳刚度的方法,并给出了具体参数。
2) Optimum stiffness distribution
最佳刚度分布
3) best rigidity characteristic value
最佳刚度特征值
4) optimal temperature
最佳温度
1.
A mathematical model of expressing the relatinnship between the optimal temperature (Tm) and the height of the catalyst bed(L ), the optimal CO conversion ratio (xCO,m)or the optimal CO composition (yco,m) and the height of the catalyst bed (L ) has been established.
建立了一氧化碳变换反应催化剂床层中最佳温度（Ｔｍ）与床层高度（Ｌ）、最佳一氧化碳转化率（ｘｃｏ，ｍ）或最佳一氧化碳浓度（ｙｃｏ，ｍ）与床层高度（Ｌ）关系的数学模型，绘制了Ｔｍ－Ｌ、ｘｃｏ，ｍ－Ｌ和ｙｃｏ。
5) the best concentration
最佳浓度
1.
The article discussed influences that common-ion effect and Complex effect act on deposition solubility on gravimetry,and deduced the calculating formula of controlling the best concentration of precipitator to make precipitation complete during the concurrence of the mentioned two effects.
对重量分析中既存在同离子效应又存在络合效应时沉淀剂对沉淀溶解度的影响进行了探讨,并推导出两种效应同时存在时要使沉淀反应完全,应控制沉淀剂最佳浓度的计算公式。
2.
According to teaching practice of weight analysis of analysis chemistry,the influences that identical ionic effect and coordination effect on deposition solubility were discussed,and the calculating formula for the best concentration of precipitator to make precipitation complete was deduced in the article.
根据分析化学理论课重量分析一章的教学实践,讨论同离子效应和配位效应同时存在时对沉淀溶解度的影响,推导出要使沉淀反应完全,沉淀剂最佳浓度的计算公式。
6) optimum temperature
最佳温度
1.
The effect of Fe_2O_3 on medium temperature FGD characterization,optimum temperature in fixed bed and proportion of Fe_2O_3 and CaO were studied in the experiment.
研究了加入氧化铁添加剂后,对中温烟气脱硫性能的影响和对固定床干法脱硫最佳温度的影响,氧化铁配比对氧化钙脱硫性能的影响等。
2.
The optimum acidity and optimum temperature of cellulose degradation by cellulase were obtained.
用微量热法测定了不同酸度和不同温度下纤维素酶降解纤维素的热功率—时间曲线,应用热动力学理论和对比进度法解析出反应的米氏常数(Km)和最大速率(Vmax),并得出速率常数k2,建立速率常数与酸度和温度间的关系式,从而获得纤维素酶降解纤维素的最佳酸度和最佳温度。
3.
The optimal mathematical models on the axial optimum temperature and maximum synthetic rate for a continuous heat exchange ammonia converter were established.
建立了连续换热式氨合成塔轴向最佳温度和最大合成率的优化模型,采用牛顿迭代法和龙格-库塔法对模型进行了数值解。
补充资料：JPZ型三向等刚度橡胶减震器
分子式：
CAS号：
性质：JPZ-type tridirective equal rigid rubber mounting 橡胶减震器的一种。具有x、y、z三个方向等刚度、等自震频率。按负荷大小可分为JPZ-1、JPZ-2两种型号。由中央金属芯柱、伞形金属罩及橡胶连接而成，模压法生产。可满足导弹控制仪等设备的隔震和抗冲击要求。
CAS号：
性质：JPZ-type tridirective equal rigid rubber mounting 橡胶减震器的一种。具有x、y、z三个方向等刚度、等自震频率。按负荷大小可分为JPZ-1、JPZ-2两种型号。由中央金属芯柱、伞形金属罩及橡胶连接而成，模压法生产。可满足导弹控制仪等设备的隔震和抗冲击要求。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条