1) Line contact
线啮合
2) point-line meshing
点线啮合
1.
Comparing with normal involute gear transmission,point-line meshing gear transmission has a serial of advantages: good meshing capability,small abrasion,high efficiency,low noise,great carrying capacity,high intension,long life etc.
介绍了点线啮合齿轮的基本理论,分析了其传动的参数选择和几何尺寸,通过实验验证和工程应用,发现点线啮合齿轮传动与常规的渐开线齿轮传动相比,具有跑和性能好、磨损小、效率高、噪声低、承载能力大、强度高、寿命长等一系列优点,具有广阔的应用前景。
3) cycloidal gearing
摆线啮合
4) Line engagement deive
线啮合传动
5) point-line meshing gear
点线啮合齿轮
1.
Development of DQJ point-line meshing gear series reducer;
DQJ点线啮合齿轮减速器的研制
2.
Use SolidWorks as modeling software,through SolidWorks API which is its further development interface,and VB,developed a calculation and 3D modeling system for spur or helical point-line meshing gears,which will improve the efficiency and precision of designing,decrease the cost and have broad application prospect.
介绍了点线啮合齿轮的基本理论及其齿廓曲线方程,以SolidWorks为造型软件,通过二次开发接口SolidWorks API,应用VB语言开发了点线啮合直齿、斜齿齿轮设计计算及三维造型系统,提高了设计效率和精度,降低了设计成本,具有广阔的应用前景。
3.
The bending strength of an involute gear and the point-line meshing gear is calculated with this software.
运用此软件对相同参数的渐开线齿轮与点线啮合齿轮进行弯曲强度的有限元精确计算,得出点线啮合齿轮比渐开线齿轮弯曲强度提高11。
6) Teeth faces mesh with the cone lines
齿面与棱线啮合
参考词条
补充资料：齿轮双面啮合检查仪
见齿轮综合检查仪。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。