1)  electric field
端点场强
1.
Because the electric field at the end of the uniformly charged line is not decided,we calculated the electric field distribution on the axis of uniformly charged cylinder.
本文针对均匀带电直线端点场强的不确定性 ,提出了均匀带电圆柱体轴线上的场强计算 ,结果表明 ,在不同条件下 ,均匀带电圆柱体的场强表达式将变成均匀带电直线、均匀带电圆面的场强。
2)  end point
端点
1.
The author discusses end point property andobtin.
定义了一族解析函数B(λ,α,β),导出该族中函数的积分表达式;借助算子理论建立B(λ,α,β)的包含关系,讨论端点性质;由此推出族中函数的偏差定理。
3)  endpoint
端点
1.
Improvements of Speech Endpoint Detection Based on Short Time Average Magnitude;
基于短时平均幅度的语音端点检测的改进
2.
That the strong point of Bspline curve endpoint is not at the top point of relevant characteristic polygon results in some problems for the application of curve.
针对 B 样条曲线的起点不在相应的特征多边形的顶点上,给应用该曲线带来一定困难的问题,结合水泵叶轮的计算机辅助设计,提出一种处理 B样条曲线端点的方法,此法引入了调整参数,可以灵活地控制所控制曲线的形状,以满足机械工程计算机辅助设计的需要。
3.
This dissertation firstly analyzes the research state of the endpoint security technology, and the deficiency of current endpoint management system in usability and adaptability.
而随着越来越多的公司将其核心业务在intranet/LAN上运行的时候,内网安全及端点安全的要求也与日俱增,计算机终端对网络的安全访问作为一个无法回避的问题呈现在人们面前。
4)  extreme points
端点
1.
A type of integrating formula only with relation to extreme points of integration interval;
一类仅和积分区间端点有关的求积公式
2.
Unattainable points and extreme points of ■;
关于■的不可达点和端点
3.
The main result is that the extreme points of almost CL-space are also the extreme points of its double-dual space.
首先根据定义证明了Ba-nach空间c0是CL-空间,然后给出了几乎CL-空间的端点的一些性质,主要证明了几乎CL-空间的端点也是其二次对偶空间的端点。
5)  extreme point
端点
1.
A characterization of non-extreme points of numerical ranges;
数值域非端点的一个刻画
2.
The extreme points for the set consist of n×n matrixs;
n阶方阵集合的端点性质
3.
In this paper, we characterize extreme points and locally and unformly rotund points of Cesaro vector-valued sequence spaces and give their criteria.
刻划了Cesaro矢值序列空间的端点和局部一致凸点,给出了它们的判据。
6)  point
端(点)
参考词条
补充资料:饱和场强
分子式:
CAS号:

性质:铁电体处于饱和极化状态时的外电场强度。在外电场作用下铁电体内的电畴起初随外电场强度正的提高逐步取向排列,极化强度相应增加,当达某一场强时,极化强度不再增加,因电畴均按外电场方向定向排列整齐,继续增加外电场强度也不会提高极化强度,相当于饱和极化状态。烧成后的压电陶瓷要经过人工极化处理(外加直流电场)后才具有压电性。极化场强一般为2.5~4.5kV/mm,具体数值根据不同材料组成及制品尺寸而定。当外电场强度过高时,可能导致材料击穿而破坏。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。