1) voltage inter-loop
电压内环
1.
By the theoretical analysis and the simulation, it is concluded that the proportional or proportion-integral regulator should be used in the engineering design of voltage inter-loop incurrent-voltage and velocity-current-voltage multi-loop system, instead of using integration regulator.
对于转速 -电流 -电压多闭环系统 ,通过理论分析和仿真实验 ,认为电压内环的工程优化设计 ,应采用比例或比例积分调节器进行校正 ,而不宜选用积分调节
2) inner loop of pressure
压力内环
3) inner pressure ring
内压环
4) inner current control
电流内环
5) inner overvoltage
内过电压
1.
The feasible suggestions for the study on the inner overvoltage of HVDC transmission system are proposed.
基于金沙江一期向家坝—南汇±800kV直流输电工程的具体参数,利用电磁暂态计算软件EMTP-RV,针对直流输电控制保护动作特性对内过电压的影响进行了详细的仿真计算和分析总结,并对高压直流输电内过电压的研究方法提出了可行性建议。
6) inner pressure during charging
充电内压
1.
2 V NiMH power cell, such as discharge capacity, discharge voltage, quick charge, highrate dischargeability, inner pressure during charging and chargeability/dischargeability at high/low temperature, was researched.
2V方型MH Ni动力电池的放电容量、放电电压、快速充电、高倍率放电、充电内压和高低温充放电等性能。
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条