1) squeezing property
强挤压性
1.
And by introducing an equivalent norm,the squeezing property of operator and Lipszchize continuity are proved,thereby the existence of inertial fractal set in H_1 space is testified.
研究有阻尼 ,没有 Marangoni效应的色散 KDV- KSV方程 ,通过引入等价范数 ,证明算子的强挤压性及L ipszchize连续性 ,从而证明了惯性分形集在 H1 空间的存在性。
2.
The Lipschitz continuity and the squeezing property of the semigroup S(t) associated with the initial-value problem of complex Ginzburg-Landau equation are proved.
通过证明Ginzburg-Landau方程的初边值问题的解半群S(t)的Lipschizt连续性和强挤压性,从而获得复Ginzburg-Landau方程惯性分形集存在性。
2) bearing strength
挤压强度
1.
Bearing strength tests have been carried out on carbon fibre-reinforced epoxy laminates with different ply directions.
通过对碳纤维复合材料层压板不同铺层方向的试件进行钉孔挤压强度试验，得出影响挤压强度的主要因素，并建立了挤压强度估算公式。
2.
The bearing strength of composite joints embedded delamination is measured both under RTD and hygrothermal conditions.
通过试验测定了含脱层的复合材料连接件在常温干燥和高温湿热环境下的挤压强度数值，探讨了含脱层的连接件在不同环境下强度和刚度数值的变化。
3.
An analysis based on two-dimensional finite element model was performed to evaluate the bearing strength of bolted composite joints.
利用ABAQUS软件,加入失效分析程序对层合板螺栓连接挤压强度进行分析。
3) coldworking strengthened
挤压强化
1.
Fatigue life of coldworking strengthened parts has been researched, by fatigue test and detail fatigue rating.
通过疲劳试验和DFR方法,研究了LY12CZ挤压强化连接孔的疲劳寿命增益。
4) cold holes expansion
孔挤压强化
6) Extrusion fortification rice
挤压强化米
补充资料：冲击挤压(见冷挤压)
冲击挤压(见冷挤压)
impact extrusion
ehongji jiya冲击挤压(impaet extrusion)见冷挤压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条