1) temperature glide
温度滑移
1.
This paper proves the character of temperature glide of R407C by this experiment.
结果表明用R4 0 7C替代R2 2时 ,对现有的空调系统和生产设备无需作大的调整 ,还验证了R4 0 7C在蒸发器上存在温度滑移 ,并就进一步提高R4 0 7C房间空调器性能提出了建议。
2) velocity slip and temperature jump
速度滑移和温度跳跃
3) slip velocity
滑移速度
1.
In the present paper, combination of pressure difference method with gas-liquid inter-phase slip velocity was proposed to measure the phase holdups in TPALRs.
将压差法与气?液相间滑移速度相结合,提出了利用压差法测量三相区局部相含率的新方法,将测得的局部固含率进行轴向平均并与由颗粒装填量计算所得的固含率进行比较,证明了此方法的可靠性。
2.
Distribution law of its inner Flow Field and separation characteristic of oil and water phases flow were obtained according to the analysis of distribution of oil phase volume concentration, distribution of oil phase slip velocity and separation efficiency under different flux.
数值模拟了油水分离用水力旋流器油水两相流,分析了水力旋流器内部油相体积浓度分布、油相滑移速度分布以及不同流量下的分离效率,得到了水力旋流器内部流场的分布规律和油水两相流的分离特性。
3.
Local slip velocity is an important factor in mass,momentum and heat transfer of riser reactors.
这种颗粒团尺寸的不均匀性导致了滑移速度沿径向也存在着梯度分布 。
4) Slip length
滑移长度
1.
So, the study on contact slip length will help to improve the reliability of the contact and the lifespan of the space relay.
触点滑移长度的研究有利于提高触点接触可靠性及继电器产品寿命,本文通过对簧片与触点结构建模,得到了触点切向角及接触角变化量计算方程;通过建立接触系统的柔度、装配尺寸链计算方程确定了触点滑移长度。
5) velocity slip
速度滑移
1.
Different slip behaviors were observed including velocity slip, interfacial no-slip and negative slip.
本文采用非平衡分子动力学方法对纳米通道内的Couette流动进行了研究,计算获得了不同壁面和流体间势能作用强度下通道内流体的速度分布和密度分布,反映出可能存在的速度滑移、表观无滑移和负滑移现象,并探讨了速度滑移程度和壁面作用强度之间的关系。
2.
A nonlinear model based on the finite element method was provided to compute the static characteristics of partial porous air thrust bearing considering the tangential velocity slip at the bearing-film interface.
建立了局部多孔质气浮轴承的理论模型,该模型考虑了轴承气膜交界面处的切向速度滑移。
3.
Experimental results show that velocity slip do not obey the Beavers mode, but it could be approximated by an added equivalent clearance.
在对多孔质气体静压轴承分析时 ,多孔质材料内部的惯性效应以及多孔质轴承表面的速度滑移对所建立的简化数学模型的应用是一个很大的障碍 。
6) slip velocity
速度滑移
1.
First order slip velocity and jump temperature boundary conditions are employed to deter- mine the developing flow and heat transfer in the entrance region of a microtube.
对微圆管进口区运用一阶速度滑移和温度跳跃边界,考察了Kn、动量调和及热调和系数对流动与换热特性的影响机理和规律。
2.
The characteristics of gas flow velocity,friction coefficient,and heat transfer(Nusselt number) in micro-channels under the conditions of equal heat flow,equal wall temperature,and no temperature grads were simulated by using the model of Navier-Stokes equations and slip velocity boundary conditions.
结果表明:气体稀薄效应可显著减小管内的摩擦阻力和努塞尔数,增大气体流速;壁面的速度滑移和温度跳跃对微圆管内换热特性的影响相反,温度跳跃的影响更大;等热流加热与等壁温加热两种情况下,努塞尔数随克努森数的变化趋势明显不同。
补充资料:铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条