1) stretching strain rate
拉伸应变速率
2) SSRT
慢应变速率拉伸
1.
Stress Corrosion Cracking of polythionic acids(PSCC) of 304 SS were investigated by SSRT,SEM and metallographic analysis.
采用慢应变速率拉伸试验(SSRT)、扫描电镜断口分析以及金相显微组织分析等方法对304不锈钢连多硫酸应力腐蚀开裂(PSCC)行为进行了研究。
2.
The stress corrosion behavior of 304 stainless steel in the solution saturated by H2S and the standard solution of NACE was studied with electrochemical test and slow strain rate tension(SSRT) test.
用电化学测试及慢应变速率拉伸试验(SSRT)方法对304不锈钢在饱和H2S溶液和NACE标准溶液中的应力腐蚀行为进行研究。
3.
Stress Corrosion cracking of acids media(PSCC) of duplex stainles steel and ferritic stainless steel were investigated by SSRT,SEM and metallographic analysis and evaluate stress corrosion cracking sensitivity of ferritic stainless steel and duplex stainless steel in acids media.
采用慢应变速率拉伸试验(SSRT)、扫描电镜(SEM)断口分析以及金相显微组织分析等方法对TP405铁素体不锈钢及2205双相不锈钢在酸性介质中应力腐蚀开裂(PSCC)行为进行了研究。
3) slow strain rate tension
慢应变速率拉伸
1.
The stress corrosion cracking (SCC) behaviors of X80 pipeline steel in near-neutral pH solutions were studied using electrochemical potentiodynamic scanning,slow strain rate tension(SSRT) and scanning electron microscopy.
采用电化学动电位扫描技术、慢应变速率拉伸(SSRT)试验和扫描电镜观察研究了X80管线钢及焊接接头在NS4溶液中的应力腐蚀行为。
2.
5% NaCl solution was investigated by using slow strain rate tension,scanning electron microscope and transmission electron microscope.
通过慢应变速率拉伸测试、扫描电镜及透射电镜分析等研究了2519铝合金在T6、T8热处理状态下,在空气和3。
3.
The interaction between mechanics and electrochemistry during the stress corrosion cracking (SCC) of 7075 aluminum alloy was studied using slow strain rate tension (SSRT) technique.
用慢应变速率拉伸(SSRT)技术研究了7075铝合金在应力腐蚀过程中的力学与电化学交互作用。
4) slow strain rate test
慢应变速率拉伸
1.
The behavior of solid copper-induced embrittlement(SCIE) of TC11 titanium alloy was investigated using slow strain rate tests(SSRT) and constant load tensile tests(DLTT) at different temperatures.
分别采用慢应变速率拉伸、恒载荷拉伸加载方法研究了TC11钛合金在不同温度下的Cu脆行为,Cu与钛合金试样表面的接触分别采用离子束增强沉积和机械压合法实现。
2.
The behaviors of stress corrosion cracking (SCC) of 7075 aluminum alloys with different heat treatments had been tested at various polarization potentials with slow strain rate test (SSRT) method.
为了探讨极化对铝合金SCC敏感性的影响,采用慢应变速率拉伸技术研究了不同恒电位极化条件下7075T6、7075T7351、7075RRA铝合金的应力腐蚀行为。
5) apparent elongational strain rates
表观拉伸应变速率
1.
The processability of low density polyethylene (LDPE) and linear low density polyethylene (LLDPE) resins under same specified conditions was compared through the measurements of their resistance to elongational flow and apparent elongational strain rates.
介绍了1种测定表观拉伸流动性能的新方法,通过测量不同聚合物的拉伸流动阻力和表观拉伸应变速率,来比较它们的加工流动性能,并就低密度聚乙烯和线型低密度聚乙烯的分子结构对加工流动行为的影响进行了探讨。
6) tensile strain rate
拉伸应变率
1.
Effect of tensile strain rate on spall fracture in 20 steel;
拉伸应变率对20钢层裂特性的影响
2.
According to the curve,the spall strength,the thickness of spall scab and the tensile strain rate under different condition were obtained.
根据所得曲线波形计算出相应条件下的层裂强度、层裂片厚度以及各自的应变率,最后得到层裂强度随拉伸应变率变化的关系曲线。
补充资料：拉伸应力-应变曲线
分子式：
CAS号：
性质：在拉伸试验中，对试样所受的拉力与相应应变所作的坐标曲线图。它能形象地表示出应力与应变的对应关系。试验常在恒定的应变速率与伸长率下进行。
CAS号：
性质：在拉伸试验中，对试样所受的拉力与相应应变所作的坐标曲线图。它能形象地表示出应力与应变的对应关系。试验常在恒定的应变速率与伸长率下进行。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条