1) Working Nip Angle
工态啮角
1.
The fixed mass principle was put forward and the working nip angle was imported,which were successfully applied into the chamber research of cone crusher.
为开发圆锥破碎机新型层压曲线腔形,基于分层破碎,提出固定质量原则,引入工态啮角,并成功应用于圆锥破碎机腔形的开发研究。
2) Locking Angle
啮角
1.
A caculation of Locking Angle for the Complex Motion Jaw Crushers Fragment Cavity;
复摆腭式破碎机破碎腔啮角的计算
3) condition for the tooth double profile surfaces to engage
双面啮合工作状态
1.
The total bending deformation of the ship navigating in waves may make the center distance of bearing supports of the gearing arranged along the ship longitudinal direction reduced,thus maybe make the gearing operate under the condition for the tooth double profile surfaces to engage~([1]).
船舶在波浪中航行时,船舶的总体弯曲变形会使沿船体纵向布置齿轮机构的轴承座中心距产生缩减,从而可能使齿轮机构处于双面啮合工作状态[1]。
2.
This reduction of the center distance will lead to the additional radial pressure to develop between two engaging gears of the gearing,thus make the gearing operate under the condition for the tooth double profile surfaces to engage.
这种中心距缩减会导致互相啮合的两齿轮间产生附加的径向压力,从而使齿轮机构处于双面啮合工作状态。
3.
Under certain conditions, this reduction of the center distance will lead to create additional radial pressures between gearing teeth and between journals and bearings, thus make the gearing operate under the condition for the tooth double profile surfaces to engage.
在一定条件下 ,这种中心距缩减会导致互相啮合的两齿轮间产生附加的径向压力 ,从而使齿轮机构处于双面啮合工作状态。
4) Variable nip angle
变啮角
5) engage angle of curved surface
曲面啮角
6) short addendum
小啮合角
1.
Thelaminated short addendum shaving-cutter,which is designed by adoption of the theory in this paper,has better universality.
本文介绍了小啮合角剃齿刀的设计原理和有关计算公式，并给出设计实例。
补充资料：啮啮
1.咬嚼。 2.引申为侵蚀。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条