1) Multiplex force circulation
合力循环
2) coupled cyclic stress
耦合循环应力
1.
Through a series of tests on saturated clay,the effect of stepped loading history and coupled cyclic stress on dynamic shear modulus and damping ratio under large strain(>10-3) was examined.
对试验结果的分析表明:采用多个试样单级加载与采用一个试样分级加载试验得到的初始骨干曲线、动剪切模量与阻尼比都较为一致,采用分级加载试验测定动剪切模量与阻尼比是可行的;耦合循环应力中的轴向偏差应力对扭转向应力-应变滞回圈的倾斜程度及动剪切模量与阻尼比都有显著影响,尤其当扭转向循环剪应力较小时,可以认为轴向偏差应力的大小控制着动剪切模量的增大量,受扭转向剪应力的影响,轴向应力–应变滞回圈的变化模式较为复杂。
3) cyclic stress
循环应力
1.
Experimental study on shearing deformation behavior of saturated clay under cyclic stress;
循环应力下饱和黏土剪切变形特性试验研究
2.
The cyclic stress?strain curves of ZA27 alloy with different treatment have been obtained in constant strain amplitude condition and the corresponding microstructure,the fractograyh obtained under different treatment condition are presented.
研究了ＺＡ２７ 合金在室温下的低周疲劳性能， 得到两种处理状态下ＺＡ２７ 合金在恒应变幅下的循环应力—应变曲线， 并对两种状态下合金的显微组织及疲劳试件断口进行了显微分析。
3.
The cyclic stress strain properties of ZA27 alloy and ZCuSn10P1 at ambient temperature were studied in this paper The cyclic stress strain curves of them are obtainaed The results show alloy ZA27displayed the cyclic softing character.
本文对ＺＡ２７和ＺＣｕＳｎ１０Ｐ合金在室温下的循环应力应变特性进行了测试，得到了两种材料的循环应力应变曲线。
4) hydraulic circulation
水力循环
1.
Optimization of hydraulic circulation in irregular garden waters;
不规则园林池塘水力循环的运行优化
2.
On the premise of not influencing the original landscape of Humble Administrator's Garden,the hydraulic circulation measures were taken to perform a test of water body restoration,and the improvement effect of water quality was analyzed with the calculation results of flow field simulated by FLUENT software under the different operation conditions.
在不影响拙政园原有景观的前提下,采用人工水力循环措施进行水体修复试验,并结合FLUENT软件对不同工况下的流场模拟计算结果,分析了对水质的改善效果。
3.
The results indicate that,by regulating the manual hydraulic circulation system,a condition with bigg.
园林池塘水面变化极不规则,采用有限体积法对实施人工水力循环的园林池塘水体流动数学模型进行求解。
5) power cycle
动力循环
1.
Parameter analysis of combined power cycle with liquefied natural gas cold energy recovery;
液化天然气冷能回收混合动力循环参数分析
2.
On characteristics of heating source and cooling source in nuclear heating reactor cooperation, The paper advances a new kind of power cycle in which a multicomponent mixture as the work fluid, ammonia water Rankine cycle, describes its running principle, and compares it with steam Rankine cycle in the same situation.
根据核供热堆热电联供热源和冷源特点，提出了与之相适应的新型动力循环－非共沸混合工质氨水朗肯循环。
6) thermodynamic cycles
热力循环
1.
The coefficient of performance of the absorption heat transformer under the ideal and real thermodynamic cycles conditions are calculated based on the second law of thermodynamics and thermodynamic properties of the LiBr aqueous solution.
介绍了提升工业废热温位的吸收式热变换器的工作原理 ,工质的热力循环过程。
补充资料：循环系统的进化鱼的循环系统
李瑞端绘
[图]
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条