1) latent heat transfer
潜热传热
2) latent heat
潜热
1.
Application of a New Model for Latent Heat Treatment to Simulation on Microsegregation;
一种新型潜热处理模型显微偏析数值模拟的应用
2.
Treatment of latent heat in calculations for solidification of heavy castings;
大型铸件凝固计算中的潜热处理方法
3.
The effect of composition on the latent heat of solidification for the Al-Cu alloy;
Al-Cu合金成分变化对其凝固潜热影响的研究
3) Latent heat of fusion
熔化潜热
1.
%) and Al-28%Mg-14%Zn alloys used for thermal energy storage applications,such as the specific heat capacity including solid and liquid state;the mass density in the temperature range 30～500℃;the melting temperature and the latent heat of fusion.
利用差示扫描量热仪(DSC)和H-90型膨胀仪,对潜热储能材料A l-34%Mg-6%Zn和A l-28%Mg-14%Zn合金的热物性参数进行了测定,如固、液态时的比热容,30~500℃间的质量密度,熔化温度和熔化潜热等。
2.
We report the calculated results of the latent heat of fusion Δμ ls and the melting temperature T m as a function of cluster size.
给出了团簇熔化潜热和熔点随团簇尺寸的变化关系 ,表明团簇熔化潜热和熔点强烈依赖于团簇的原子数 。
4) latent heat
融化潜热
1.
The paper mainly introduces some important property parameters of food concerned with cold process and related formula,such as water ratio,density,latent heat,breathing heat,specific heat,heat conductivity,heat diffusivity,etc.
本文主要介绍了与食品冷加工过程有关的几个重要物性参数及相关的计算公式,如含水率、密度、融化潜热、呼吸热、比热、导热系数、热扩散系数等,对于设计食品的制冷、冻结及冷链系统有重要的作用。
5) Transformation Latent Heat
相变潜热
1.
Ti 50 Ni 40 Cu 10 alloy is prepared and its transformation latent heats and hysteresis under conditions of various heat treatment processes and thermal cycling times are systematically investigated by differential scanning calorimeter (DSC).
结果表明 ,马氏体相变潜热ΔHB2→B1 9和逆马氏体相变潜热ΔHB1 9→B2 随固溶温度的升高而明显降低 ,随退火温度的升高略微降低。
6) latent heat efficiency
潜热效率
1.
Sensible heat efficiency,latent heat efficiency and dehumidification coefficient of performance(DCOP) were employed to evaluate the performance of silica gel wheel and lithium chloride wheel.
以显热效率、潜热效率和除湿性能系数作为评价指标,通过实验比较了硅胶和氯化锂转轮的除湿性能,研究了运行参数(处理空气进口湿度、温度,再生温度,处理风量)对转轮除湿性能的影响。
2.
The influences of sensible heat efficiency and latent efficiency on total heat efficiency in diffe-rent climatic areas of China were determined according to weight coefficients of sensible heat efficiency and latent heat efficiency,showing that the weight coefficient of latent heat eff.
以板式全热交换器为例,通过推导全热交换器的显热、潜热和全热3种效率之间的关系式,用权重系数的概念分析了在我国不同地区气象条件下,显热效率和潜热效率对全热效率的影响程度。
3.
The relational expression for total heat efficiency,sensible heat efficiency and latent heat efficiency of total heat exchanger is established with weight coefficient method.
利用权重系数建立了全热换热器的全热效率、显热效率及潜热效率三者的关系式,根据显热、潜热效率权重系数判定显热效率、潜热效率对全热换热器全热效率的影响程度。
参考词条
补充资料：比潜热
分子式：
分子量：
CAS号：
性质：物质的物理性能指标之一，指潜热Q除以质量m。符号为ι。ι=Q/m。SI单位为焦/千克。
分子量：
CAS号：
性质：物质的物理性能指标之一，指潜热Q除以质量m。符号为ι。ι=Q/m。SI单位为焦/千克。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。