2) hinge configuration
铰链机构
1.
Based on numerical simulation,research was made on the wear state of hinge configurations in a crane-block mechanism.
以数值仿真技术对曲柄滑块机构中的铰链摩擦副磨损状态进行了研究 ;考虑到压力和温度的影响 ,建立了铰链机构的磨损仿真模型 ;对机构中三对铰链接触处的磨损提出了具体的算法方案 ,在VisualBasic环境下编写了通用程序 ,获得了更加准确的仿真结
3) Four-hinge mechanism
四铰链机构
1.
In this paper,considering the integrity tube under the external pressure from the elastic deformation and elastic-plastic deformation two stages,analysis and calculation on the destruction of the elastic-plastic deformation base on the Four-hinge mechanism.
本文从完整管体受外压发生弹性形变和弹塑性变形两个阶段考虑,在基于四铰链机构原理基础上对管体弹塑性破坏变形进行分析计算,得出完整管体的抗挤毁压力。
4) toggle lever mechanism
杠杆铰链机构
5) four-bar linkage mechanisms
铰链四连杆机构
1.
This paper introduces the wide application value of the four-bar linkage mechanisms in this modern maneuverability of big radar,after analyzing the accuracy and simulating the impetus of two different four-bar linkage mechanisms.
针对铰链四连杆机构在大型雷达天线折叠过程中的广泛应用,通过两种铰链连杆机构的刚体动力学计算分析、精度定性分析的比较,获取铰链四连杆机构在工程实际应用中应该注意和考虑的几点事项。
6) four-bar linkage
铰链四杆机构
1.
With the integrating plane geometry knowledge and principle of relative motion,a method for proving and identifying the pattern of four-bar linkage is introduced.
利用平面几何知识与相对运动的原理相结合来求证与判别铰链四杆机构的型式,该方法简单易行,而且还揭示了铰链四杆机构的不同型式之间的联系与本质区别。
2.
A analytical synthesis method of four-bar linkage in the special configtiration, in which thecoupler curve has a five-point contact with its tangent (Burmesters point), is presented.
给出了在一种特殊位形情况下综合连杆曲线具有5点接触直线（Burmester点）的铰链四杆机构的解析方法。
补充资料：计算机输入/输出控制系统(见计算机输入/输出系统)
计算机输入/输出控制系统(见计算机输入/输出系统)
computer input/output control system
iisuanii shuru/shuehu kongzhi xitong计算机输入/输出控制系统(com-puter inPut/ou中ut eontrol system)见计算机输入/输出系统。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条