1) coincidence error
重合误差:
2) coincidence error
重合误差
3) Misalignment e rror with refference point
基准不重合误差
4) coincidence error limit
重合误差极限
1.
This paper introduces the block diagram and the basic operation principle of the particle counter,and discusses calibrating methods and specification concept of the particle counter,including resolution,coincidence error limit,and size calibration,they are regulated in national standard GB/T Hydraulic fluid power-Calibration of liquid automatic particle counters.
文章阐述了颗粒计数器的基本组成及工作原理,讨论了”国家标准GB/T1885 4-2 0 0 2液压传动颗粒计数器的校准”中规定的颗粒计数器分辨率、重合误差极限、尺寸校准等技术指标的校准方法及这些指标的概念。
5) colour registration error
彩色重合误差
6) superposition
重合
1.
The resolution of removing transformation is removed first, and removing equations are given; then the resolving expression of superposition through three revolving is given; it is based on projection when the dual points were obtained.
一般移动变换分解为先平移,并给出移动变换的平移方程组,求得重合的对应点之后,在投影的基础上,经三次旋转,使得同向合同不重合的形体达到重合,并建立了解析表达式。
2.
The general removal transformation is being resolved as a translation in advance, and then after finding the superposed point of correspondence to obtain the analytical expression of superposition by means of three time of rotation based on projection.
给出了移动变换定义;一般移动变换分解为先平移,求得重合的对应点之后,在投影的基础上,经三次旋转达到重合的解析表达式;给出了相关的程序框图。
参考词条
补充资料：套刻重合
分子式：
CAS号：
性质：晶片上每一点定义的矢量，这是基片几何图形的矢量位置和套刻图形(可以由光致抗蚀剂组成)相应点矢量位置之间的差称作。= 。
CAS号：
性质：晶片上每一点定义的矢量，这是基片几何图形的矢量位置和套刻图形(可以由光致抗蚀剂组成)相应点矢量位置之间的差称作。= 。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。