1) punching shear depth
冲切高度
2) punching strength
冲切强度
1.
In this paper, the analysis on axisymmetrical ultimate punching strength of concrete slabs is presented by using Hsich-Ting-Chen strength criterion.
本文采用Hsich-Ting-Chen强度准则,对轴对称条件下混凝土板冲切强度进行了分析,推导出破坏时的冲切面上正应力和剪应力表达式;采用刚塑性模型,给出了轴对称破坏机构,再利用虚功原理求得破坏荷载的上限。
2.
The carrying capacity of a reinforced concrete slab under concentrated load depends on its bending strength and punching strength.
集中力作用下钢筋砼板的承载力取决于板的抗弯强度与冲切强度。
3.
According to the upper-bound plasticity theory and the proposed punching failure modes of concrete slab, a unified punching strength formula under circle and rectangular pressure is presented and verified systematically by the corresponding concrete slab punching theory, testing data published in the literatures and concerning concrete slab punching formula recommended by China Code.
依据塑性上限分析理论和合理的混凝土板冲切强度破坏模式,求出了圆形和矩形分布荷载下混凝土板冲切强度的统一表达式。
4) slice depth
切削高度
1.
This paper studies in detail the dropping cut method which the Bucket Wheel Excavator normally adopts,and on this basis,deduces carefully some more exact formulas of slice depth,width and height in dropping cutting process.
本文针对斗轮挖掘机经常采用的水平切削方式作了较为详细的分析，在此基础上推导了水平切割时切削厚度、切削高度和切削宽度的较为精确的计算公式，为斗轮挖掘机水平切削时的受力分析和功率计算提供了较为可靠的理论依据。
5) cutting height
切口高度
1.
Based on mechanics principles, this paper calculates the cutting height and cutting angle of tubular building directional demolition.
根据力学原理 ,计算了钢筋混凝土筒形结构定向倾倒拆除的切口高度和切口角度 ,分析了筒形结构的定向倾倒过程。
2.
The cutting height and cutting angle of directional dernoiltion of tubularbuilding are analysed and calculated according to mechanics principles.
根据力学原理，分析讨论了钢筋混凝土筒式结构定向倾倒的切口高度和切口角度。
6) High coupling
高密切度
补充资料：半冲切
分子式：
CAS号：
性质：为了把压敏标签容易从隔离层面剥下，在冲切时只冲断标签层，而隔离层不冲切的方法。
CAS号：
性质：为了把压敏标签容易从隔离层面剥下，在冲切时只冲断标签层，而隔离层不冲切的方法。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条