1) aerodynamic stiffness
气动刚度
1.
Put forward a new method for long-span bridge buffeting analysis which using quasi-steady aerodynamic stiffness and unsteady aerodynamic damping based directly on wind tunnel test.
提出采用准定常气动刚度与基于试验的非定常气动阻尼进行气动修正的大跨度桥梁抖振计算新模型。
2) pneumatic stiffness
气承刚度
1.
Tracked with pneumatic stiffness, transfer equation of external pressure to internal and Helmholtz frequence, frequence-shift characteristics for roof structures with idealized closed wall and with wall having opening, and similarity criterion theory for pneumatic stiffness are discussed, the key action of wall flexibility in theoretical study is considered.
以气承刚度理论为主线阐述了内压传播方程及赫姆霍兹频率、四周封闭屋盖结构及墙面开孔屋盖结构的频移特性和气承刚度的相似性模拟准则,考虑了墙体柔度在理论分析中的关键作用。
2.
Wind-Induced dynamic response of the membrane structures belongs to fluid-structure coupling interaction, which includes coupling factors-added air-mass and pneumatic stiffness.
膜结构的非线性风振响应是流固耦合的共同作用问题 ,其中包括耦合因素——附加空气质量与气承刚度的计算。
3) gas film stiffness
气膜刚度
4) dynamic stiffness
动刚度
1.
Discussion on the Dynamic Stiffness of Wire-EDM Machine;
快走丝电火花线切割机床动刚度研究
2.
How to improve structural dynamic stiffness of machine tools;
如何提高机床结构的动刚度
3.
Application of a single - chip microcomputer to measuring of dynamic stiffness of crane;
用单片机测量起重机的动刚度
5) Dynamic stiffness
动态刚度
1.
Study on vertical dynamic stiffness and damp of running tire;
轮胎垂直滚动动态刚度和阻尼的研究
2.
Effect of pretension on dynamic stiffness of high-speed angular contact ball bearing
预紧对高速角接触球轴承动态刚度的影响
3.
The dynamic stiffness of pre-loaded hollow cylindrical roller bearing is analyzed.
对预载荷空心圆柱滚子轴承的动态刚度进行了分析。
6) Dynamic Rigidity
动刚度
1.
Application of dynamic rigidity and dynamic penetration to consolidated foundation test;
动刚度和动力触探在强夯地基检测中的应用
2.
Study on the nonlinear dynamic rigidity characteristics of the initiative magnetic bearings
主动磁力轴承非线性动刚度特性研究
3.
Its dynamic rigidity is lower,last blade stellite alloy was heavily eroded which caused the increasi.
从最终的效果看,造成3、4号瓦振动异常的 原因并不是转子的残余不平衡引起的,主要原因是由于低压转子轴承座系悬臂支撑方式,相对来说动刚度较 低,同时末级叶片司太立合金严重冲蚀,导致蒸汽激振力增加,致使机组在30 MW负荷以下或空负荷时瓦振正 常,在30 MW以上机组振动随负荷升高而增大。
补充资料:JPZ型三向等刚度橡胶减震器
分子式:
CAS号:
性质:JPZ-type tridirective equal rigid rubber mounting 橡胶减震器的一种。具有x、y、z三个方向等刚度、等自震频率。按负荷大小可分为JPZ-1、JPZ-2两种型号。由中央金属芯柱、伞形金属罩及橡胶连接而成,模压法生产。可满足导弹控制仪等设备的隔震和抗冲击要求。
CAS号:
性质:JPZ-type tridirective equal rigid rubber mounting 橡胶减震器的一种。具有x、y、z三个方向等刚度、等自震频率。按负荷大小可分为JPZ-1、JPZ-2两种型号。由中央金属芯柱、伞形金属罩及橡胶连接而成,模压法生产。可满足导弹控制仪等设备的隔震和抗冲击要求。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条