1) wet-expansion deformation
湿胀变形
1.
These factors affect each other, so it is difficult to distinguish wet-expansion deformation and find out its regularity.
蓄水后坝踵压应力增长不是个别大坝特有的现象,其原因可能与水头、灌浆、温度、坝高(指施工期坝体上升)以及湿胀等因素有关,这些因素相互影响,增加了分析工作的困难,特别不易单独分离出湿胀变形及其变化规律。
2) press expansion
扩胀变形
1.
In order to simulate the acceleration pulse in impact tests, the design method of the acceleration pulse generator by the multi-segment tubes with different thicknesses based on the theory of metal tubes press expansion was researched.
为模拟碰撞实验中的加速度波形的要求,以金属圆管扩胀变形原理,通过不同壁厚圆管的分段组合形式研究了波形发生器的设计方法。
3) bulging deformation
鼓胀变形
1.
Bulging Deformation Analysis and Safety Assessment of Coking Tower;
焦炭塔鼓胀变形分析与安全评定
2.
The skirt from bottom to top of the tower was changed,and a nip convention out ektexine of coke tower was added to change the accepting force with coke tower in order to avoid the bulging deformation and cold crack with welding line below the coke tower.
将炼油行业传统焦炭塔的下裙座支撑改为上裙座支撑,在焦炭塔外壁增加一夹套,改变了焦炭塔的受力,避免了塔体下部鼓胀变形和焊缝冷裂纹的产生。
3.
In slashing running conditions,the bulging deformation of coke drums may appear after some years.
在苛刻的作业工况下,焦炭塔运行若干年后会出现筒体鼓胀变形。
4) swelling deformation
膨胀变形
1.
Tests on swelling deformation of expansive soils;
宁夏膨胀土膨胀变形特征的试验研究
2.
Effect of swelling deformation on stability of expansive soil slope
膨胀变形对膨胀土边坡稳定性的影响
3.
This paper founds the relation of porosity, permeability and swelling deformation under considering swelling deformation made by coal adsorption gas, and by analysis it can be concluded that as gas stress in the coal bed increases, the swelling deformation becomes bigger, the porosity being much smaller, so as to weaken the permeability of the coal bed and make it difficult for gas flow.
在考虑煤骨架吸附变形特性的情况下,得出了孔隙率、渗透率和膨胀变形之间的关系式。
5) expanding distortion
胀大变形
6) drum deformation
鼓胀变形
1.
There ′re many factors that influence the result of compression test for cast iron, among which the internal friction of material and the drum deformation of sample are most important.
影响铸铁压缩试验结果的因素很多 ,其中最主要的是材料内摩擦力及试件的鼓胀变形。
2.
After many years run, the drum deformation and cucurbit deformation appear.
一个生产周期为48小时，使焦炭塔经历了循环的升温、降温，整个塔体在室温与480℃之间循环变化，致使焦炭塔在运行若干年后出现塔体鼓胀变形和葫芦状变形。
补充资料：大坝内部变形观测(见水工建筑物变形观测)
大坝内部变形观测(见水工建筑物变形观测)
daba neibubianxing guanCe大坝内部变形观测见水工建筑物变形观测。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条