1) slope bar
斜杆
1.
A new way to calculate the stiffness factor of the slope bar in structural mechanics based on the method of instant center in mechanics of theory is presented.
以理论力学瞬心概念为基础,结合结构力学位移法,提出了一种计算斜杆刚度系数的简易方法———瞬心法。
2) angled ejector pin
斜推杆
1.
The deformation of angled ejector pin is prevented and the service life of the mould is extended,therefore the run cost is reduced.
针对倒扣塑件内部空间较小,斜顶机构比较单薄的特点,介绍了一种被动式斜顶机构,与传统设计相比,该机构不仅解决了斜推杆的变形问题,提高了模具的使用寿命,而且节约了模具制作成本,同时实现了完全自动化生产。
2.
A double angled core-pulling mechanism was developed and with the angled ejector pin,the stripping of buckle and the act of angled core-pulling were implemented.
利用斜推杆完成卡扣脱模及斜抽芯动作,保证了产品的表面质量,降低了产品的成本。
3.
Special angled ejector pins with direction of motion controlled were applied to the formation of two barbs on internal surface.
外表面侧凹用滑块抽芯,内表面2处倒钩用斜推杆及通过控制运动方向的特殊斜推杆成型。
3) strut
[英][strʌt] [美][strʌt]
斜压杆
1.
In order to thoroughly study the spatial strut-and-tie theory on the punching failure of pile caps, two critical problems, value about end cross dimension of strut and calculation on strut strength, have been carried out based on the literatures and the research results from author.
为加深对承台冲切破坏空间桁架理论的研究,运用文献资料与作者既有研究成果,分析探讨了该理论中的两个关键问题:斜压杆端截面尺寸的取值与斜压杆强度的确定。
4) compression strut
斜压杆
1.
Based on load transmission mechanism of space truss for pile caps, the simulation of compression struts of pile caps was tested.
基于桩基承台的空间桁架传力机理，进行了承台斜压杆应力场的模拟试验。
5) main diagonal strut
主斜压杆
6) outer-inclined pipe
外斜杆
1.
Through column and outer-inclined pipe,the horizontal ring is superimposed one by one.
穹顶的上半部为压缩环,下部为张力环,水平环采用H型钢组成的具有足够刚度的空间三角形钢桁架,通过立柱及外斜杆,层层叠加,最终形成稳固的穹顶。
补充资料：UR-9双螺杆式空气压缩机
UR-9双螺杆式空气压缩机
I甲之一9双螺杆式空气压缩机翻戳
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条