1)  Hybrid Ⅲ 50th
Hybrid Ⅲ 50th
1.
In order to specify the dynamic responses of Hybrid Ⅲ 50th dummy neck under the low speed rear impact,and find the solution to improve the biofidelity and performance of the dummy neck.
为了明确Hybrid Ⅲ 50th假人颈部的低速后碰撞动力学响应特性,提出了提高其生物逼真度的方法和途径。
2)  HybridⅢ50th dummy
HybridⅢ50th假人
1.
The frontal impact test was carried out by using HybridⅢ50th dummy with 6-point safety belt,and the contrast analysis for the injury parameters of head and chest between 6-point restraint system and 3-point restraint system was also carried out.
利用HybridⅢ50th假人佩戴六点式安全带进行了前碰撞试验,并对比分析了三点式安全带约束下的头部和胸部损伤值。
3)  Hybrid
Hybrid
1.
The Study of Hybrid E-learning Model;
Hybrid综合学习模式研究
2.
This paper,based on the characteristics of the ethernet port three kinds of modes,including(Access),Hybrid,Trunk,combined with some projects that the author participated in,puts forward the vivid(installing) the method of the ethernet port Hybrid mode,to increase the safety of the network,and resolve the tight lacking problem for the IP address etc.
针对以太网端口三种模式Access,Hybrid,Trunk的特点,结合工程实践,提出灵活配置以太网端口Hybrid模式的方法,以提高网络的安全性,解决IP地址紧缺问题等。
4)  Hybrid Inlining
Hybrid Inlining
1.
Improvement on Hybrid Inlining Approach from Mapping DTD to Relational Schema;
从DTD映射到关系模式方法Hybrid Inlining的改进
5)  LH
Lazy Hybrid
6)  Hybrid lattice
Hybrid lattice
参考词条
补充资料:in-plane hybrid composite
分子式:
CAS号:

性质:由具有两种或两种以上纤维的混杂层铺叠而成的复合材料,基体一般为高聚物,是混杂复合材料的一种。这种混杂形式又称A型混杂。混杂层可以是异种纤维编织的织物或排置的无纬布。由于混杂纤维束制备工艺复杂,很少采用。层内混杂复合材料除具优异力学性能外,特别是由于异种纤维间互相分散的程度增大,彼此制约的能力增强因而抗裂纹扩展性能更好。层内混杂复合材料的成型方法同一单一纤维复合材料,固化工艺条件取决于所用的高聚物基体。该种混杂复合材料的混杂层制作比较复杂。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。