1) rectangular narrow channel
矩形窄通道
1.
Heat transfer enhancement in rectangular narrow channel with longitudinal vortex generators;
矩形窄通道内带纵向涡发生器的传热强化
2) Narrow rectangular channel
矩形窄缝通道
1.
The characteristics of two-phase flow pressure drop were experimentally investigated in narrow rectangular channels with large width-height ratio(1.
5×60 mm)矩形窄缝通道内水的两相沸腾流动特性进行了实验研究。
3) Rectangular narrow channel
窄间隙矩形通道
1.
Research of determinant law of boiling heat transfer enhancement in rectangular narrow channel;
窄间隙矩形通道沸腾传热强化判定准则研究
2.
A critical heat flux analysis model,of annular flow in rectangular narrow channels,is obtained by taking reference to the predictive analysis model, of critical heat flux of annular flow in round tubes,and suitably considering the special structural features of rectangular narrow channels.
根据窄间隙矩形通道的流道结构特点,参考圆管环状流临界热流密度(CHF)预测解析模型,得到了窄间隙矩形通道内环状流CHF解析模型。
4) rectangular channel of narrow aspect ratio
窄矩形管道
1.
In this peper,an experimental study of fully developed turbulent air flow in rectangular channel of narrow aspect ratio with two opposite rib-roughed walls was performed to determine the effect of the rib pitch-to-height on friction factor and heat transfer coefficients with low Renolds number.
通过实验研究了低雷诺下，粗糙窄矩形管道中。
5) rectangular channel
矩形通道
1.
A set-up for test of fluid flow friction characteristic was designed and built,which was used to measure the flow parameters for the rectangular channel with the staggered holed-baffles.
设计和建立了一套流动阻力特性试验装置,对流体流经交错布置多个开孔折流板的矩形通道时的阻力特性进行了测试。
2.
The flow and heat transfer in a rectangular channel with a flat heated plate in the middle section was experimentally investigated.
通过实验研究了中心截面带有加热平板的水平和倾斜矩形通道入口段的混合对流换热,该矩形通道和加热平板均采用高热导率材料制作,矩形通道外壁面绝热。
3.
An analytical study has been done on the critical heat flux (CHF) in the rectangular channel with a closed bottom, in which a liquid film and a vapor flow exist in a countercurrent annular flow.
分析研究了在底部封闭矩形通道内逆流汽液两相流条件下的临界热流密度的发生机理。
6) rectangular duct
矩形通道
1.
A theoretical investigation is presented for fully developed flow of power law fluid through a rectangular duct,this modelling is based upon the Patankar's control volumemethod -a famous numerical simulation method of fluid flow and heat transfer.
针对假塑性幂律流体在矩形通道中充分发展流动问题,用帕坦卡方法作数值分析,文中讨论了不等距网格的划分方法和粘度系数的插值方法。
2.
The mixed convection heat transfer of the entrance region in a vertical rectangular duct with a uniformly heated plate was experimentally investigated when the forced air flowed upward and downward.
通过实验研究了内置均匀加热板的垂直矩形通道入口段混合对流换热的温度场和阻力特性。
3.
A numerical study is conducted for laminar flow heat transfer in rectangular ducts in thethermal entrance region with one side heated and three sides adiabatic.
对单面加热矩形通道热入口段的层流对流换热问题进行了数值模拟研究,给出了不同截面比的局部努赛尔数。
补充资料：胎圈过窄、子口窄、圈窄等
分子式：
CAS号：
性质：又称胎圈过窄、子口窄、圈窄等。轮胎工业中指两胎圈宽度不一致的现象。
CAS号：
性质：又称胎圈过窄、子口窄、圈窄等。轮胎工业中指两胎圈宽度不一致的现象。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条