1) Pressure roller
压带轮
2) spin pulley
旋压带轮
1.
Nonlinear finite element analysis of spin pulley;
旋压带轮的非线性有限元分析
3) pinch roller arm
压带轮臂
4) skirt+traverse plate+press pulley
波状挡边+横隔板+压带轮
5) extrusion-belt
挤压带
1.
Aimed at Jetta steering knuckle,the technology of two forging steps in one heat was presented,which combined precision pre-forging by extrusion-belt obliterated extrusion with open finish-forging.
以捷达轿车转向节为研究对象,制定了挤压带式可分凹模闭塞挤压精密预制坯和开式终锻成形相结合的“一火两锻”成形工艺。
2.
Aiming at the obliterated extrusion forming with extrusion-belt of pre-forging part,the influences of punch geometry,extrusion-belt length,mould temperature and lubrication to forming technology were discussed by using DEFORM,then the technology parameters used in the forming were acquired.
针对挤压带式闭塞挤压精密预制坯的成形过程,以DEFORM软件为工具,研究了冲头形状、挤压带长度、模具工作温度、润滑等条件对成形工艺的影响,确定了成形过程中需采用的工艺参数。
3.
In this paper, a new precision forming technology is put forward, which combines pre-forging by separable cavity die extrusion-belt type obliterated extrusion with post-forging.
针对轿车转向节这类复杂枝杈类锻件的成形,提出可分凹模挤压带式闭塞挤压预制坯和终锻相结合的精密成形新工艺,介绍了可分凹模闭塞挤压工艺研究的实验结果和数值模拟结果,提出的新工艺具有降低设备公称压力要求和材料利用率高的重要结论。
6) relaxed area
卸压带
1.
The full stress-relaxed area of 2 m,the partial stress-relaxed area of 2～6 m and stress concentration area of 6～12 m were achieved.
结果表明:充分卸压带为2 m,部分卸压带为2~6 m,集中应力带为6~18 m。
参考词条
补充资料：板带轧制压下规程(见板带轧制规程设计)
板带轧制压下规程(见板带轧制规程设计)
draughting schedule for plate and strip rolling
bandai zhazhi yaxia guieheng板带轧制压T规程(draughting，ehedule forplate and strip rolling)见板带札制规程设计。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。