1) T-junction
T形结点
2) T shape
“T”形
3) T-shaped
T形
4) T joint
T形接头
1.
T joints fatigue strength improving by hybrid heat treatment process after tungsten inert-gas arc remelting;
基于TIG电弧重熔的焊后复合处理工艺改善T形接头疲劳强度的研究
2.
Microstructure and properties of T joint by EBW-brazing hybrid welding;
电子束焊—钎焊复合焊T形接头组织性能分析
3.
Influence of welding sequence of subsection welding on residual stress of T joint;
分段焊的焊接顺序对T形接头残余应力场的影响
5) T-shape forging
T形锻件
1.
Conventional integral cavity die structure can not be applied to the extrusion molding of T-shape forging due to its special profile.
T形锻件因形状所致,其挤压成形无法采用传统的整体凹模结构。
6) T-wedge
T形楔块
1.
Difficulties in design of injection mould with different side-concave structure were anˉalyzed,and then design points of two stage side core-pulling mechanism were proposed,including angular cam and angle guide pillar assembly,T-wedge and T-wedge assembly and T-wedge and angle guide pillar assembly.
现分析了塑件不同侧凹结构对注射模设计造成的困难,以及弯销—斜导柱组合、T形楔块—T形楔块组合和T形楔块—斜导柱组合的二级侧抽芯机构的设计要点,总结了塑件侧抽方向与模具开模方向的夹角大小对二级侧抽芯机构设计的影响,为复杂塑件成型模的设计开辟了新思路。
参考词条
补充资料：点接触结（pointcontactjunction）
点接触结（pointcontactjunction）
简便的方式是将超导体一削尖的端点（约0.1μm端径）施压在另一超导体小面上而接触成点接触结，它是一种弱连接。由于压力可调节，就可选择最好所需最适宜接触性能。点接触结可用于制作磁强计和微波接收与发射等装置。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。