1) defect level
缺陷水平
1.
There are lots of articles researching on pull system model,which often neglecting the defect of parts or assuming the defect level equals to zero directly in production process.
关于拉式系统模型的研究文献很多,但它们往往忽略生产过程零部件缺陷的存在或者直接假设缺陷水平为零。
2) planar disfigurement
平面缺陷
1.
Based on SAPV—95, the safety function M and the method to get the reliability index β which can be used to weighs safety grades of pressure pipes with planar disfigurements under steady load are proposed in this paper.
以 Lr为广义强度 ,以 Kr为广义应力 ,参照 SAPV— 95规范得出了功能函数 M,据此对静载下含平面缺陷的压力管道进行了可靠性分析 ;提出了计算其可靠性指标的快速收敛的迭代算法 ,并分析了可靠性指标与 Lr 和 Kr的均值及变异系数的关系 ,得出了可靠性指标能定量衡量静载下含平面缺陷的压力管道的安全状况的结论。
2.
Based on SAPV 95, by means of level 2 method, the safety function and the method to get the probability of failure which can be used to weigh and forecast the safety state of pressure pipes with planar disfigurements under steady load are proposed.
参照 SAPV-95规范 ,用第 2水平法对静载下含平面缺陷的压力管道进行了可靠性分析 ,得出了功能函数。
3) the flaws formed due to the water in concrete evaporated
失水缺陷
4) fruit defects
水果缺陷
5) plane flaws
平面型缺陷
6) not the formation of defects
不平整缺陷
补充资料：点缺陷(见晶体缺陷)
点缺陷(见晶体缺陷)
point defect
点缺陷point defeet见晶体缺陷。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条