1) load-pull
负载牵引法
1.
In case of large-signal S parameters are difficult to achieved and source impedance and load impedance at 1710MHz~2110MHz provided by the manufacture is useless,a load-pull approach based on Agilent s ADS software is provided in order to obtain required input and output impedance.
在大信号S参数无法获得而厂家提供的1710 MHz~2110 MHz范围内的源阻抗和负载阻抗参数又不能用时,利用一公司的ADS软件,采用负载牵引法得到了输入和输出阻抗。
2.
this paper adopts the load-pull to present the tracking algorithm for the output power contour on the Smith char by using the microwave power automated test system.
结合Smith圆图,利用微波大功率自动调配器测试系统,采用负载牵引法,给出搜索等功率圆曲线的算法。
2) load-pull method
负载牵引法
1.
The input and output impedance of MRF18030 transistor are obtained by 2-tone load-pull method.
采用2-tone负载牵引法得到了LDMOS晶体管MRF18030的输入和输出阻抗。
3) load-pull
负载牵引
1.
Simulation design of microwave power amplifier using load-pull method;
基于负载牵引方法的微波功率放大器仿真设计
2.
Automatic Measurement of Load-pull Property of Power Solid-state Amplifiers at Microwave Frequency;
微波功率固态放大器负载牵引特性的自动测试
3.
The second order harmonic output matching networks are optimized by load-pull method.
并利用负载牵引法对二次谐波匹配网络进行了优化。
4) load pull
负载牵引
1.
A typical configuration of power load pull system and ΔGt method to verify the accuracy of the whole system were introduced.
介绍了典型功率测量负载牵引系统组成,以及验证系统准确性的ΔGt方法。
2.
This paper discusses a new microwave power device measurement system-load pull measurement system,and compares it with tradition power device measurement system;This paper also presents the black diagram of the measurement system,the structure and its primary specifications of programmable tune
本文介绍一种新的微波功率器件测量装置——负载牵引测量系统,并与传统测量装置进行比较;给出了测量系统原理框图和关键部件——程控调配器的结构及其主要技术指标。
5) Load pulling
负载牵引
1.
A simulating load pulling technique has been proposed for FET power amplifier analysis by using HP Eesof Series IV software.
用 HP EESOF Series IV软件的负载牵引法对功率放大器进行分析 ,给出了匹配电路的基波特性及谐波特性对功率放大器性能的负载牵引结果 ,提出了功率放大器匹配电路谐波设计的思想 ,并给出了设计实
6) traction load
牵引负载
补充资料：牵引法
牵引法 牵引法 推拿手法名。即拉法。参见该条。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条