1) implantation temperature
注入温度
1.
This paper analyzes the internal conversion electronic Mossbauer Spectrum of pure iron and GCr15 steel samples at different implantation temperatures and also discusses temperature influence on implantation results.
本文用内转换电子穆斯堡尔谱分析不同温度下注入的纯铁和GCr15钢,并讨论注入温度对改性的影响。
2) nonisothermal injection
非等温注入
3) teeming height
注入高度
1.
The simulation experiment shows that the shorter teeming time is,the less air entrainment of tapping is;the lower teeming height is,the less air entrainment of tapping is.
模拟实验结果表明,注入时间愈短,注流带入的气体量愈少;注入高度愈低,注流带入的气体量愈少。
4) injection rate
注入速度
1.
Study on injection rate of third level formation with polymer flooding in Daqing Oilfield.;
大庆油田三类油层聚合物驱注入速度研究
2.
Selection of the rational injection rate for reservoir with polymer flooding;
聚合物驱合理注入速度的选择
3.
This paper uses reservoir numerical simulation method to study the effect of injection rate on the displacement efficiency of polymer flooding and analyzes the reason of the effect.
运用油藏数值模拟方法研究了注入速度对聚合物驱油效果的影响 ,并对注入速度影响聚合物驱效果的原因进行了分析。
6) injection depth
注入深度
1.
Experimental study of injection depth and fuelling effects during supersonic molecular beam injection on the HL-2A tokamak;
HL-2A托卡马克超声分子束注入深度和加料效果研究
2.
Microwave power, treatment time, heartwood and sapwood and moisture content all have effect on drug loading, injection depth and oxygen index to various degrees, but none of them has obvious law.
试验结果表明:微波处理后,杉木的渗透性得到明显改善;微波功率、处理时间、心边材和含水率对载药量、注入深度和氧指数有不同程度的影响,但均没有呈现出明显的规律性;心边材对结果影响很小,可忽略这一因素的影响;径向、弦向和纵向三个方向之间的注入深度差异显著,总体表现为纵向大于弦向大于径向。
补充资料:铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条