1) complex support structure
复合支挡结构
1.
The soil nail & anchor of complex support structure was applied in a cut slope project in Hunan,which appeared distability accident in 2005.
湖南省某挖方边坡工程采用土钉加锚杆复合支挡结构,在2005年发生了失稳事故。
2) cement-soil composite braced retaining structure
水泥土复合式支挡结构
3) retaining structure
支挡结构
1.
The time-dependent property of cohesive soil pressure of retaining structures;
支挡结构粘性土土压力的时变特性效应
2.
Calculation of earth load on landslide retaining structure based on planar sliding
从平面滑动思考滑坡支挡结构荷载计算
3.
Anchor anti-slide pile is regarded as a kind of retaining structures made up of anti-slide pile and anchor,at the same time,the anti-slide pile of this structure is also regarded as the beam laid on the elastic foundation and the tension of anchor is conducted as a concentrated force loaded on the pile.
将锚索抗滑桩看作由锚索和抗滑桩共同组成的支挡结构系统,同时,将其中的抗滑桩视为搁置在弹性地基上的梁,并将锚索拉力作为集中力加在抗滑桩上;应用初参数法分别建立了滑面上下基床参数为同一常数和滑面上下基床参数为不同常数时的计算锚索抗滑桩弯矩、剪力、挠度和转角的初参数公式。
4) supporting and retaining structure
支挡结构
1.
Through a few typical construction examples, the paper fully demonstrates effectiveness and advantage of cement clay mixing pile in supporting and retaining structure of foundation pit and sums up some successful experiences for reference and selection.
本文通过几个典型的工程实例 ,充分说明水泥土搅拌桩在基坑支挡结构工程中的有效性和优越性 ,并总结出几条成功经验 ,可供同行们参考选用。
5) supporting structure
支挡结构
1.
Theoretical analysis and engineering application of supporting structure of framed pre-stressed anchor bars;
框架预应力锚杆支挡结构的理论分析及工程应用
2.
Optimum design of grillage supporting structure with pre-stressed anchor bars on loess slope;
黄土边坡框架预应力锚杆支挡结构的优化设计
3.
Analysis and design of supporting structures on loess slope are very complicated problems.
黄土边坡支挡结构的分析与设计是工程设计的一大难题。
6) support structure
支挡结构
1.
Through the in?situ test,abtaining the phenomenon that the efficient pressure in mucky loam arises sharply when the displacement of support structure reaches to a certaint value.
通过现场监测数据分析 ,获得了在复杂地层中在支挡结构水平位移达到一定值时 ,淤泥质亚粘土层中有效应力会有突然增大的现象 ,为今后深基坑工程设计提供了一种土压力取值的依据。
2.
Integrating road cut slope engineering of Chongqing City of China,the author studies new type support structure of cut slope (self support structure system),its mechanics calculation model and method of design,and construct art etc.
结合重庆市渝北区党校农税公路边坡的支挡工程 ,研讨了适合于在地形、地质、地上建筑物较为复杂区域采用的新型支挡结构 -自支撑结构体系的力学计算模型与设计计算方法 ,以及施工技术要
补充资料:第一工位挡料结构
多工位级进冲模的第一工位挡料结构有其特色,即能设置在任意需要的地点推出挡料销。在图1中的主要零件是挡料销和滑板。不需限位时,挡料销低于下模平面,需要时可推动滑板,通过前端斜面,使挡料销伸出下模平面实现挡料。
图1 第一工位挡料结构
1-下模 2-挡料销 3-滑板
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条