说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 轻型支挡结构
1)  light supporting structure
轻型支挡结构
1.
Experimental analysis of earth pressure on the light supporting structure;
轻型支挡结构的土压力试验分析
2)  high-light-retaining structure
高轻型支挡结构
1.
The application of high-light-retaining structures include prestressed anchor cable poling,anchor slab retaining wall and reinforced earth retaining wall was introduced accordance with its structure compositions,suitable conditions,practical application and field measurement based on the engineering cases used in Yunnan province.
结合云南省高速公路工程中高轻型支挡结构实体工程建设及原位测试分析,从结构组成、适用条件、工程应用及原位测试四个方面介绍了锚索桩板墙、锚定板挡墙和加筋土挡墙等高轻型支挡结构的应用情况。
3)  light shoring
轻型支挡
1.
Various new light shoring structures used in the Nan Kun Railway are described with their design and construction,as well as their applicable condition
介绍了南昆铁路应用的各种新型、轻型支挡结构及其设计与施工经验,并论述了适用条件。
4)  the selection of retaining structures
支挡结构选型
5)  retaining structure
支挡结构
1.
The time-dependent property of cohesive soil pressure of retaining structures;
支挡结构粘性土土压力的时变特性效应
2.
Calculation of earth load on landslide retaining structure based on planar sliding
从平面滑动思考滑坡支挡结构荷载计算
3.
Anchor anti-slide pile is regarded as a kind of retaining structures made up of anti-slide pile and anchor,at the same time,the anti-slide pile of this structure is also regarded as the beam laid on the elastic foundation and the tension of anchor is conducted as a concentrated force loaded on the pile.
将锚索抗滑桩看作由锚索和抗滑桩共同组成的支挡结构系统,同时,将其中的抗滑桩视为搁置在弹性地基上的梁,并将锚索拉力作为集中力加在抗滑桩上;应用初参数法分别建立了滑面上下基床参数为同一常数和滑面上下基床参数为不同常数时的计算锚索抗滑桩弯矩、剪力、挠度和转角的初参数公式。
6)  supporting and retaining structure
支挡结构
1.
Through a few typical construction examples, the paper fully demonstrates effectiveness and advantage of cement clay mixing pile in supporting and retaining structure of foundation pit and sums up some successful experiences for reference and selection.
本文通过几个典型的工程实例 ,充分说明水泥土搅拌桩在基坑支挡结构工程中的有效性和优越性 ,并总结出几条成功经验 ,可供同行们参考选用。
补充资料:第一工位挡料结构

多工位级进冲模的第一工位挡料结构有其特色,即能设置在任意需要的地点推出挡料销。在图1中的主要零件是挡料销和滑板。不需限位时,挡料销低于下模平面,需要时可推动滑板,通过前端斜面,使挡料销伸出下模平面实现挡料。



图1  第一工位挡料结构
 1-下模  2-挡料销  3-滑板

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条