1) length of weaving area
交织区长度
2) weaving length
交织长度
1.
Micro-simulation software-VISSIM was utilized to analyze the reasonable distance of weaving section between exit and entrance pertaining to diamond interchange on the urban expressway,and the relationship between average speed and weaving length were studied in the case of different traffic flow combinations and different waving flow ratios.
为了确定城市快速路菱形立交出入口交织区的合理长度,应用Vissim微观仿真模型,研究在不同流量组合及交织流量比情况下,菱形立交出入口区间平均速度与交织长度的关系。
3) length of weaving sectio
交织段长度
4) weaving length
交织长度车辆
5) braided multipath with two paths of equal length
相同长度的交织多路径
6) weaving length
(车辆) 交织路段长度
补充资料：变形区长度
变形区长度
length of deformation zone
b ianxingqu ehangdu变形区长度(length of deformation:one) 轧制时轧件同轧辊接触弧的水平投影长度，一般以l表示，l=双sina，式中R为轧辊半径，a为咬入角。从几何关系还可以求得l与R及压下量从的关系为l /_.，从2，_劫2.__L___.，~~:，、，~=心R从一二笋.，由于岑~相对于R助小得多，故计算 V-一4’一一4’一’‘’--一一~一，一，·~中均用其近似值l、翻丫天瓦。 (余望)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条