1) location deviation
定位偏差
1.
The linear measurement principle of flattened diameter of the ocular cornea and the location deviation of the cone prism which is used in the applanation tonometer are introduced.
介绍了用于压平眼压计的圆台压平棱镜进行角膜压平直径线性测量原理及定位偏差分析;着重讨论了光通量补偿及角膜压平面积线性测量原理;也介绍了利用计算机图形学设计和制作通量补偿片的方法。
2.
In view of large location deviation of the feature point images in vision-based pose measurement of parallel mechanism,a compensation method is proposed on the basis of approximation solution of parallel mechanism pose.
针对并联机构位姿视觉测量中特征点像点定位偏差大的问题,提出了基于并联机构位姿近似求解的补偿方法。
2) positional error
定位偏差
1.
The paper,which is aimed at the readable and measurable of PIV image with dirtect measurement,discusses the error law in the procedure among analog image acquisition and the central position of a particle spot and proposes a testing method used to estimate positional error of particle spot.
本文针对ＰＩＶ技术的直接测量法中图像的可读性和可测性，讨论了从模拟图像到数字图像，最后到粒子像斑中心位置的确定过程中的误差规律；并提出一种称之为粒子像斑定位偏差综合评估的试验方法。
2.
The paper,which is aimed at the readable and measurable of PIV image with direct measurement,discusses the error law in the procedure among analog image acquisition and the central position of a particle spot and proposes an experiment method used to estimate positional error of particle spot.
针对PIV技术的直接测量法中图像的可读性和可测性，讨论了从模拟图像到数字图像，最后到粒子像斑中心位置的确定过程中的误差规律；并提出一种称之为粒子像斑定位偏差综合评估的试验方法。
3) deviation and mispla cement
偏差定位
4) locating deviation
定位偏差量
1.
The variation of locating deviation from Hypo81,GELor-p and Genetic methods with interspace angle is analyzed with 149 ML≥2.
0级地震149个,针对每个地震记录的具体情况,综合考虑最大空隙角、近台距离、远台距离、台数等因素,选取台站分布相对合理的4~12个台站,利用首都圈数字地震台网交互处理系统提供的Hypo81、GELor-p、Genetic3种定位方法分别进行定位处理,将3种定位结果与全国地震月报目录进行对比得到定位偏差量,定量分析了3种定位方法的定位偏差量随空隙角的变化,探讨了Hypo81、GELor-p、Genetic3种定位方法的定位效果、稳定性及适用性。
5) bus positioning deviation
总线定位偏差
6) flux orientation angle deviation
磁链定位偏差角
1.
In this paper, the flux orientation angle deviation δ =0°, which is the sufficient essential condition for the vector control system to be accurately decoupled, is discussed, and the method for observing this condition directly is also proposed.
本文分析了矢量控制系统正确解耦的充要条件，即磁链定位偏差角δ＝０°；提出了直接观测解耦充要条件的方法；研制了模型参考自适应实验系统。
补充资料：逼近函数的偏差
逼近函数的偏差
deviation of an approxmating function
通近函数的偏差【山血位扣of ana即.油加tiI犯如‘丘.;yoo.e。。e np:6二:狱a沁川e‘中y。二明。。1 逼近函数g〔K和一个给定函数f任叨之间的距离p匆，f).在同一个类叨内可以考虑用不同度量p，譬如一致度量 p(g，f)一碧笃}g(x)一f(x)I，以及积分度量 /(。，，)一(i一(·)一，(·):“·)’‘’，p一和别的度量.至于逼近函数的类K则可以用代数多项式、三角多项式，还有f关于某个正交系的正交展开的部分和，这些部分和的线性平均，以及一些别的集之、
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条