1) Stagger crankshaft
错拐曲轴
1.
Using ANSYS software, the finite element analysis for the stagger crankshaft of a 60°V6 vehicle gasoline engine was conducted under extreme operation conditions.
应用ANSYS软件,对某60°夹角V6车用汽油机的错拐曲轴进行了不同极限工况下的有限元计算,尤其对该曲轴的载荷和约束条件做了较为详细的讨论,得到了该错拐曲轴的应力分布,并校核了其静安全强度。
2.
The structural strength difference between stagger crankshaft and common crankshaft and the influence of Various loads and different sliding bearing clearances on stagger crankshaft strength are studied.
以90°夹角的某V型6缸柴油机为例,应用有限元分析方法,研究探讨了采用错拐结构前后曲轴强度的变化,以及不同载荷、不同主轴承间隙等因素对错拐曲轴强度的影响,并通过实验验证了有限元分析的正确性。
3.
The analytical method based on FEA and experiments is used to study the structural strength of diesel engine stagger crankshaft.
通过对比表明:理论分析与实验实测结果具有较好的一致性,针对错拐曲轴所采用的计算分析方法与实验方法均是合理可行的。
2) split-pin crankshaft
错拐曲轴
1.
Influence of Constraint Condition on FEA for Split-Pin Crankshaft;
约束条件对错拐曲轴有限元分析的影响
2.
The general methods for the balancing analysis of inertia forces in the internal combustion engine(ICE) that adopted split-pin crankshaft technology was studied in this paper.
针对某V6柴油机,对比分析了该柴油机采用错拐技术前后倾覆力矩及惯性力系的变化情况,结果表明,错拐曲轴平衡技术可有效抑制内燃机内部的激励载荷,是改善内燃机振动、噪声特性极为有效的技术措施之一。
3) crankshaft
[英]['kræŋkʃɑ:ft] [美]['kræŋk'ʃæft]
曲拐轴
1.
Computing method on strength analysis of combination typed tri-crankshaft;
组合式三曲拐轴的强度分析计算方法
2.
Mechanics analysis based on crankle instead of crankshaft;
活塞压缩机曲柄轴改曲拐轴的力学分析
4) Four crank
四曲拐轴
5) crankshafts/single crank throw
曲轴/单拐
6) five staggers crankshaft
五拐曲轴
1.
Free-forging process research on five staggers crankshaft of natural gas compressor;
天然气压缩机五拐曲轴自由锻工艺研究
补充资料：挨挨错错
1.谓拥挤杂乱。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条