1) Circulating current loss
环流损耗
1.
The circulating current losses as well as their suppression are analyzed in detail for these bars which have been divided into two or four groups connected in R pattern at one end.
本文简要地叙述了0°/360°/0°线棒在一端分组联接的主要优、缺点,详细地分析了线棒的一端分两组及分四组R式联接的环流损耗及其被抑制的程度。
2.
As the increasing of the capacity of the turbogenerator, the eddy current losses in the end structures and the circulating current losses in the stator bars caused by the leakage reactance of the end region increase correspondingly, and this becomes an unneglectable problem in the generator’s design.
但随着汽轮发电机单机容量的增大,由端部漏磁场引起的端部结构件涡流损耗及定子绕组的环流损耗也随之增大,成为电机设计中一个不可忽视的问题。
3.
Analysis of Circulating Current Loss of Continuous Type of Winding and Transposition Design in Power Transformer;
它的损耗,尤其是环流损耗,越来越受到人们的关注。
3) loop loss
环路损耗
4) HLL Half C Loop Loss
半环损耗
5) OLL Open C Loop Loss
开环损耗
6) air loss
气流损耗
1.
In order to test the index of air loss in the air trough for the air-jet reeds,starting with the weft insertion of air-jet loom,details introduction is made to the detection method of flatness of trough of the reeds and the tester self-developed.
为了说明喷气筘气槽的气流损耗这一重要指标,从分析喷气织机引纬原理入手,详细介绍了喷气筘气槽平直度检测的方法及自行研制的检测设备;另外介绍了直接测量气槽气流损耗的方法即便携式和台式检测仪,指出:气流损耗过大可降低喷气织机效率,通过减小喷气筘气流损耗值,可以直接提高喷气织机的效率。
2.
As to the giant size of the air loss testing equipment with expensive cost,introduction is made to the Air Loss Tester for Profiled Reeds BX-1 regarding its development and application method.
针对气流损耗的检测设备体积庞大、价格高昂的不足,介绍了BX-1型气流损耗仪的设计研发与使用方法。
补充资料：介质损耗角正切试验(见电容率与损耗因数试验)
介质损耗角正切试验(见电容率与损耗因数试验)
dielectric loss tangent test
)!eZh.sunhooJ一002匕engq一e sh一yon介质损耗角正切试验(dieleetri。1055 tangenttest)见电容率与损耗因数试验。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条