1) Cu-CeO_2-YSZ
Cu-CeO_2-YSZ阳极
1.
Cu-CeO_2-YSZ anode was prepared by tape casting and impregnating.
通过流延浸渍法制备Cu-CeO_2-YSZ阳极,采用淀粉做造孔剂,确定了多孔YSZ基体的制备工艺,主要包括造孔剂用量及流延浆料配比。
2) Cu-CeO_2-ScSZ anode
Cu-CeO_2-ScSZ阳极
1.
Intermediate temperature solid oxide fuel cells with Cu-CeO_2-ScSZ anode for direct hydrocarbon fuels
中温直接碳氢化合物固体氧化物燃料电池Cu-CeO_2-ScSZ阳极的研究
3) NiO-YSZ anode
NiO-YSZ阳极
1.
Performance of NiO-YSZ anode with NiO powder synthesized by precipitation method;
沉淀法合成NiO及NiO-YSZ阳极性能
2.
The YSZ films cells fabricated on NiO-YSZ anode and NiO-SDC-YSZ anode produced open-circuit voltage of 1.
NiO-YSZ阳极和NiO-SDC-YSZ阳极支撑的YSZ薄膜电池,在800℃时的开路电压分别为1。
4) NiO/YSZ anode
NiO/YSZ阳极
1.
The NiO/YSZ anode materials made by gel-casting process is one of the hot-spot in the areas of solid oxide fuel cell(SOFC).
NiO/YSZ阳极材料最佳干燥温度是25℃,固相含量为45vol%、采用15wt%石墨作为造孔剂,在1350℃烧成的NiO/YSZ阳极与固体电解质YSZ收缩率相匹配,氢气还原后NiO/YSZ阳极在600～800℃电导率达到800S/cm,符合SOFC阳极材料电导率的要求。
6) NiO-SDC-YSZ anode
NiO-SDC-YSZ阳极
1.
The YSZ films cells fabricated on NiO-YSZ anode and NiO-SDC-YSZ anode produced open-circuit voltage of 1.
NiO-YSZ阳极和NiO-SDC-YSZ阳极支撑的YSZ薄膜电池,在800℃时的开路电压分别为1。
补充资料：银阳极泥提银(见铜阳极泥提金银)
银阳极泥提银(见铜阳极泥提金银)
extraction of silver from silver anode slime
y In yongJ，nl tlyln银阳极泥提银(extraetion of Silve:fr()nl 511一ver anode slime)见铜阳极泥提金银
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条