1) tangential follower force
切向随从力
2) follower force
随从力
1.
Trapezoidal plates subjected to the uniformed follower forces are transformed to square plates by using coordinate transformation, and based on variational principle for the transformational quici natural frequency the corresponding eiqenequation are obtained by Ritz method.
对受切向均布随从力作用的梯形薄板，用仿射变换把它转化成正方形板，然后对变换后的拟固有频率变分式使用Ｒｉｔｚ法得到了特征方程。
2.
The general equation of the stability the dynamic analysis of the elastic rod with the vacationof cross section, subjected to arbitredly distributed tangential follower forces slong with the axis is ptoposed in this paper.
本文导出了具有中间支座的变截面杆在任意分布的切向随从力作用下的静力和动力稳定性分析的通用特征方程，并具体地分析了一端简支及一端固定的广义Ｂｅｃｋ杆、广义Ｌｅｉｐｈｏｌｚ杆、广义Ｈａｎｇｅｒ杆的静力失稳和颤振先稳之间的过渡值及相应的发散载荷、颤振载荷随中间支座的变化情况。
3.
Based on the viscoelastic differential constitutive relation and the thin plate theory,the motion equations of a linearly varying-thickness viscoelastic plate subjected to uniformly distributed tangential follower force are derived.
利用粘弹性微分型本构关系和薄板理论,对线性变厚度粘弹性矩形薄板建立了在切向均布随从力作用下的运动微分方程,采用微分求积法研究了在随从力作用下线性变厚度粘弹性矩形薄板的稳定性问题,具体对对边简支对边固支和三边简支一边固支条件下体变为弹性、畸变服从Kelvin-Voigt模型的变厚度粘弹性矩形板在随从力下的广义特征值问题进行了求解,分析了薄板的长宽比、厚度比及材料的无量纲延滞时间的变化对随从力作用下矩形薄板的失稳形式及相应的临界荷载的影响。
4) uniformly distributed follower force
均布随从力
5) tangential stress
切向应力
1.
Based on the Inglis formula, which calculates the tangential stress of the surrounding rock of geological stress field in different circumstances, programme is developed to compute the corresponding tangential stress of the surrounding rock of several underground plants, for instance, Ertan project of Sichuan according to different directions of longitudinal axle.
从地下洞室周边切向应力的英格里(Inglis)公式出发,提出针对不同环境的地应力场进行地下厂房纵轴线方位优选的简便方法,并编程计算了四川二滩等多个地下厂房不同纵轴线方向所对应的洞室周边切向应力,分析不同纵轴线方向条件下洞室周边切向应力的极值,并与实际工程所选取的纵轴线方向所对应的切向应力值比较,讨论了工程所选纵轴线的合理性以及洞室周边应力的集中程度。
2.
The compulation formulas on radial stress,tangential stress and deflection were derived.
运用平板理论 ,分析了周边固定受同心环形线载荷作用环形圆板的应力 ,并且导出径向应力、切向应力及挠度的计算公式 ,为结构设计提供了方
3.
The calculation formulae of normal stress difference,tangential stress and moment acted on the inner cylinder for the flow of power-law fluid in annulus with the inner cylinder executing a planetary motion under motive bipolar coordinate system were given.
给出了运动双极坐标系下幂律流体在内管做行星运动的环空中流动时流体作用在内管外壁上的法向应力差、切向应力和扭矩的计算公式;以可视为幂律流体的CMC水溶液为例,利用幂律流体在内管做行星运动的环空中流动的流函数分布的数值解对该流动时流体作用在内管壁的法向应力差、切向应力和扭矩进行了数值计算,并分析了内管自转和公转速度、环空偏心度以及压力梯度对其的影响;还以水为例,把利用数值解绘制的法向应力差、切向应力和扭矩的分布曲线与解析解绘制的法向应力差、切向应力和转矩的分布曲线进行了对比,两者吻合较好,说明给出的幂律流体在内管做行星运动的环空中流动时流体作用在内管外壁上的法向应力差、切向应力和扭矩的计算公式以及数值计算方法是正确的。
6) tangential force
切向力
1.
The formula for calculation of tangential force of toothed roller is derived from secondary crushing theory combined with analysis in tangential force of toothed roller mounted on single roller crusher and that has been proved by practical calculation in crusher design and it provides a new consideration for design of a toothed roller mounted crusher.
利用第二破碎理论 ,结合对单齿辊破碎机齿辊切向力的分析 ,推导出齿辊切向力的计算公式 ,并进行了实际设计计算验证 ,为齿辊破碎机设计计算提供了一个新思路。
2.
The experimental results show that the adhesion increases with the magnitude of normal load at the logarithmic rule; that tangential force increases with magnitude of normal load at the logarithmic rule; and that tangential force increases with magnitude of negative normal load at the linear rule.
结果表明,负法向力(即粘着力)随法向力的增加而呈对数规律增加;在负法向力下,切向力随负法向力的增加而线性增加;在一定负法向力下,切向力随初始法向力的增加按对数规律增加。
补充资料：随从
1.跟随﹔跟从。 2.跟从者﹔侍从者。 3.追求﹔追逐。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条