1.
DIFFERENCE METHOD FOR SOLVING THE TANGENTIAL STRESS AT THE BOUNDARY BY BEM
边界元法分析中的边界切向应力差分算法
2.
In this paper, difference method is used for solving tangential stress at the boundary on the basis of BEM.
本文在边界元法分析的基础上,用差分法计算边界切向应力。
3.
By using linear elastic theory, formulae for tangential stress on ellipse edge are derived.
根据线弹性理论,导出了椭圆裂纹边缘的切向应力的表达式。
4.
Cohesion is best defined in terms of the plot of shear stress versus normal stress given in Figure 9.
粘结力最好根据图9中剪切应力和法向应力的关系曲线确定。
5.
Study on parallel stress measurement with L_(CR) wave from surface based on LFMCW
基于LFMCW的L_(CR)波切向正应力检测方法的研究
6.
Analysis of the direction of shear fracture trend surface in triaxial unequal stress fields
三轴不等应力场下剪切破裂趋势面方向探析
7.
circumferential force
切线力, (沿着圆周作用的)切向力
8.
bit's directional cutting ability
钻头的定向切削能力
9.
Friction and cohesion are best defined in terms of the plot of shear stress versus normal stress given in Figure 9.
摩擦角和粘结力最好是根据图9中剪切应力和法向应力的关系曲线确定。
10.
Research on Stress Singularities about V-notch and Interface in Orthotropic Materials
正交各向异性材料V型切口及界面问题的应力奇异性研究
11.
The characteristics of the shear stress and flow field around a pipeline on fixed-bed with different gap-ratios in unidirectional flows
单向流定床床面上水平管道周围流场与切应力分布特性
12.
Study of Induction Orientation and Crystal Morphology of Glass Fiber Reinforced Polyolefine Pipe Extruded in Hoop Shear and Axial Tension Combined Stress Field;
周向剪切和轴向拉伸复合应力场中挤出玻纤增强聚烯烃管材的诱导取向及结晶形态的研究
13.
STUDY ON CUTTING FORCE IN RECTANGULAR GROOVE CUTTING AND SIDE DEFORMATION OF CHIP
矩形槽切削的切削力及切屑横向变形的研究
14.
Effect of Orientation of Principal Stress on the Undrained Behavior of Saturated Sand under Monotonic Shearing
饱和砂土不排水单调剪切特性试验研究——考虑剪切过程中变化的总主应力方向的影响
15.
The forces in operation have the form of lateral or tangential thrust.
作用力的形式是侧向冲断或切向冲断。
16.
The mistaken tendency of "putting money above everything else"should be corrected
“一切向钱看”的错误倾向应当得纠正
17.
maximum shear stress yield criterion
最大剪切应力屈服条件
18.
A fluid cannot withstand a shear.
流体不能承受切应力。