1) longitudinal corner crack
角部缺陷
2) angle
角部
1.
The numerical simulation of heat transfer in the continuous casting slab angle;
连铸坯角部传热过程的数值模拟
3) corner of workpiece
轧件角部
1.
Analysis of tendency of ductile fracture at corner of workpiece during grooveless rolling;
无槽轧制轧件角部的韧性断裂趋势分析
4) transverse corner crack
角部横裂
1.
Causes and countermeasures of transverse corner crack on narrow continuous casting slab;
连铸窄板坯角部横裂的成因及对策
5) corner insulation
角部保温
1.
The production mode with high aluminum level,general molecular ratio,low electric voltage and strengthening corner insulation could overcome the negative inflence that high aluminum level brought completely.
采用高铝水平、中分子比、低电压的生产模式并加强角部保温,完全可以克服高铝水平带来的负面影响。
6) longitudinal corner crack
角部纵裂
1.
Due to frequent emergencies of bleeding out by the billet longitudinal corner crack,the characteristic and mechanism of bleeding out are analyzed.
由于方坯角部纵裂漏钢事故频繁,通过分析漏钢的特点和机理,认为造成小方坯角部纵裂漏钢的主要原因是结晶器倒锥度小、结晶器液面波动及中间包过热度大、结晶器冷却水质差。
参考词条
补充资料：点缺陷(见晶体缺陷)
点缺陷(见晶体缺陷)
point defect
点缺陷point defeet见晶体缺陷。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。