1) corner crack
角部开裂
1.
The corner cracks of 150 mm by 150 mm continuous casting slabs were analyzed by way of examining the macro-structures, inclusions and metallographic structures of testing sample and it was found that the primary cause to the corner cracking is seriously inhomogeneous cooling conditions, which lead to stress concentration in the corner part of the slab, thus the corner cracking occurs in the slab.
针对 15 0mm× 15 0mm连铸坯的角部纵向开裂 ,从低倍、夹杂、金相组织方面进行分析 ,发现产生角部开裂的主要原因是严重冷却不均 ,从而造成角部应力集中 ,导致连铸坯角部纵向开裂 ,并提出改进措施。
2) angle
角部
1.
The numerical simulation of heat transfer in the continuous casting slab angle;
连铸坯角部传热过程的数值模拟
3) corner of workpiece
轧件角部
1.
Analysis of tendency of ductile fracture at corner of workpiece during grooveless rolling;
无槽轧制轧件角部的韧性断裂趋势分析
4) transverse corner crack
角部横裂
1.
Causes and countermeasures of transverse corner crack on narrow continuous casting slab;
连铸窄板坯角部横裂的成因及对策
5) corner insulation
角部保温
1.
The production mode with high aluminum level,general molecular ratio,low electric voltage and strengthening corner insulation could overcome the negative inflence that high aluminum level brought completely.
采用高铝水平、中分子比、低电压的生产模式并加强角部保温,完全可以克服高铝水平带来的负面影响。
6) longitudinal corner crack
角部纵裂
1.
Due to frequent emergencies of bleeding out by the billet longitudinal corner crack,the characteristic and mechanism of bleeding out are analyzed.
由于方坯角部纵裂漏钢事故频繁,通过分析漏钢的特点和机理,认为造成小方坯角部纵裂漏钢的主要原因是结晶器倒锥度小、结晶器液面波动及中间包过热度大、结晶器冷却水质差。
参考词条
补充资料：输卵管子宫角部种植术
输卵管子宫角部种植术
手术名。适用于 输卵管间质部或峡部阻塞。此方法术后再通率高，但复孕率较低，足月分娩率为14%～27%， 宫外孕发生率约为3%。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。