The influence of the addition of fly ash on the compressive strength of concrete was studied under the temperature match curing conditions.

According to having measured the rule of temperature development,the specimens were cured under matching curing system.

Measuring concrete temperature field distribution,law of temperature development of surface concrete and core concrete with ages were used as matching curing system of concrete.

The outstanding characteristic and superiority of non-azeotropic mixtures is their capability of temperature matching with the secondary heat transfer fluid (SHTF).

The paper introduces the purpose and principle of temperature matching of S109FA unit,analyzes load rejection phenomena of turbine during cold-state start-up,and optimized start-up procedure.

Improvements for different start up modes and their economic analyses were made,such as: start up in advance,shorten the time required to match the high pressure casing inlet steam parameters,not put the" temperature matching" to use after synchronization but later when steam leads into the high pressure casing and early withdraw the "temperature matching" etc.

Effect of curing temperature on strength of fly ash based mineral polymer;

Influence of specimen size and curing temperature on volume expansion of steel slag sand mortar;

Influence of curing temperature on autogenous shrinkage strain and stress of high strength concrete

Both the Mark VI temperature matching method and the attempering water method are described,while their advantages,shortages as well as specific operating procedures presented.