1) insulating curing
保温养护
2) curing at moisture-retention and heat-insulation
保湿保温养护
1.
It can be minimized or prevented by using low-alkali low-C3A and low hydration heat cement or adding mineral additive finer than the cement and curing at moisture-retention and heat-insulation.
采用低碱低C3A低水化热的水泥、在混凝土生产中掺入比水泥细的矿物掺合料、在混凝土浇注后采取保湿保温养护等措施可减少或避免混凝土的早期开裂。
3) curing temperature
养护温度
1.
Effect of curing temperature on strength of fly ash based mineral polymer;
养护温度对粉煤灰基矿物聚合物强度影响的研究
2.
Influence of specimen size and curing temperature on volume expansion of steel slag sand mortar;
试件尺寸和养护温度对钢渣砂砂浆膨胀性能的影响
3.
Influence of curing temperature on autogenous shrinkage strain and stress of high strength concrete
养护温度对高强混凝土自收缩应变和应力的影响
4) varying temperature curing
变温养护
5) low temperature reservation
低温养护
1.
This paper experimental studies the effect of low temperature reservation on ordinary concrete and high performance concrete.
本文实验研究了低温养护对普通混凝土和高性能混凝土的抗压强度的影响。
6) high temperature curing
高温养护
1.
Effect of high temperature curing on the early hydration characteristics of a complex binder containing steel slag
高温养护对钢渣复合胶凝材料早期水化性能的影响
2.
Mechanical performance and microstructure of fiber reinforced active powder concrete with different contents of steel fiber,polypropylene fiber and PVA fiber in high temperature curing at 90℃,200℃ and 400℃ are studied,different fibers are mixed.
研究了钢纤维、聚丙烯纤维和PVA纤维的不同掺量以及纤维复掺在90℃、200℃和400℃高温养护时活性粉末混凝土的力学性能和微观结构。
3.
The influence of contents of every component,fiber categories and contents,contents of ultra-pulverized fly ash which was found as the sixth component and quartz power which was replaced by raw fly ash in the condition of different water/binder on the strength and fluidity was reviewed;also,the influence of high temperature curing on the strength was reviewed too.
考察了各组分掺量、纤维的种类和掺量、作为第六组分的超细粉煤灰的掺量以及原状粉煤灰取代石英粉在不同水胶比条件下对RPC强度和流动度的影响,同时考察了高温养护对强度的影响。
补充资料:EPS夹芯保温板用于体育馆屋面
EPS夹芯保温板用于体育馆屋面
EPs夹芯保温板用于体育馆屋面
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条